Results 151 to 160 of about 36,017 (247)

An assessment of tailoring of lightning protection design requirements for a composite wing structure on a metallic aircraft [PDF]

The Navy A-6E aircraft is presently being modified with a new wing which uses graphite/epoxy structures and substructures around a titanium load-bearing structure. The ability of composites to conduct electricity is less than that of aluminum.
Harwood, T. L.
core   +1 more source

Laser balancing system for high material removal rates [PDF]

A laser technique to remove material in excess of 10 mg/sec from a spinning rotor is described. This material removal rate is 20 times greater than previously reported for a surface speed of 30 m/sec. Material removal enhancement was achieved by steering
Georgalas, G., Jones, M. G., Ortiz, A. L.   +2 more
core   +1 more source

Comparative Study on the Combustion Behavior and Mechanisms of Ti150 and TC11 Alloys in Oxygen-Enriched Environments. [PDF]

Materials (Basel)
Zha X, Feng K, Wang Y, Yang Y, Zeng XY, Zhang C.   +5 more
europepmc   +1 more source

Successful Emergency Removal of a Titanium Penile Constriction Ring Using Blood Aspiration and Nonpowered Bolt Cutters. [PDF]

Cureus
Weston GF, Golden BM.
europepmc   +1 more source

Sustainable Fire-Resistant Materials: Thermal, Physical, Mechanical, and Environmental Behavior of Walls with Waste from the Aquaculture Industry. [PDF]

Materials (Basel)
Peceño B, Alonso-Fariñas B, Vega G, Carrizo D, Leiva C.   +4 more
europepmc   +1 more source

Preparation of long afterglow luminescent road marking coatings and its applicability simulation. [PDF]

PLoS One
Li G, Li N, Zhang Y, Han J, Yao T, Feng X.   +5 more
europepmc   +1 more source

Potential Sustainability and Stress Resilience of Forest Trees Induced by Nanotechnology Applications. [PDF]

Plant Environ Interact
Siam AMJ, Abu-Zurayk R, Abdelkheir RM, Siam N, Shibli R, Sawwan J.   +5 more
europepmc   +1 more source

Evaluation of nano glass as a partial cement replacement on the fresh mechanical durability thermal and microstructural properties of cement paste. [PDF]

Sci Rep
Ali SM, Mohammed SA, Juma AA, Mahmood HF, Mohammed BM, Ahmad DA, Ahmad SA.   +6 more
europepmc   +1 more source

Ti-Al-V/Zn-Al-Cu Composite Materials Prepared by Zinc Melt Infiltration Technology. [PDF]

Materials (Basel)
Balejová V, Michalcová A, Bašistová M, Lichý P, Vojtěch D.   +4 more
europepmc   +1 more source

Advanced Post-Processing Techniques for Hydrophobic and Flame-Retardant Textiles. [PDF]

Polymers (Basel)
Vodyashkin AA, Makeev MO.
europepmc   +1 more source