Prevalence and patterns of dental needle tip deformation during maxillary buccal and palatal infiltration anesthesia. [PDF]
Alsaegh MA +4 more
europepmc +1 more source
Is Cone‐Beam CT Reliable for Apical Foramen Assessment? A Micro‐CT–Referenced Study
ABSTRACT This study evaluated the diagnostic accuracy of two cone‐beam CT (CBCT) dose protocols for identifying the number and trajectory deviation of apical foramina. Forty lower molars were scanned in Micro‐CT. Thereafter, all teeth were inserted into the mandible sockets and a titanium implant and an endodontically treated tooth with a cobalt ...
João Pedro de Lima +3 more
wiley +1 more source
Comparative effects of fluoride-containing and remineralization-promoting agents on artificial gastric juice-induced bovine enamel erosion susceptibility: an in vitro study. [PDF]
Jeong EJ +4 more
europepmc +1 more source
The Effect of Orthodontic Tooth Movement on Intrabony Periodontal Defects After Guided Tissue Regeneration-Part I: Human Histologic Evaluation of 20 Consecutive Cases. [PDF]
Nagy P +5 more
europepmc +1 more source
Proximal contact loss between implants loaded for more than 10 years and adjacent teeth. [PDF]
Kim H, Yoon JU, Lee JY.
europepmc +1 more source
NFATC1 dysfunction-triggered MSC senescence induces tooth aging amenable to senolytic therapy. [PDF]
Li F +9 more
europepmc +1 more source
Reactive soft tissue growth: a case report of onset post-extraction of natal tooth. [PDF]
O'Hagan-Wong K +4 more
europepmc +1 more source
Dynamic modelling and experimental validation of involute gears based on multi-damage evolution mechanisms. [PDF]
Mao H, Ding Y, Li X, Chen Y, Zhang B.
europepmc +1 more source
Related searches:
An analysis of tooth position on initial tooth contact
Journal of Oral Rehabilitation, 1983SummaryA closed circuit television movement detector was used to study mandibular movement in the form of tooth tapping, in subjects with no apparent dental disease or malocclusion. The velocity and form of various phases of movement was studied, in the transverse, sagittal and coronal planes, from measurements made on u.v.
K D, Faulkner, H F, Atkinson
openaire +2 more sources
A calculation method of tooth profile modification for tooth contact analysis technology
Journal of the Brazilian Society of Mechanical Sciences and Engineering, 2018Tooth contact analysis (TCA) technology is an approach for computerized simulation of meshing of aligned and misaligned gear, which has been widely used in the design of gears. In TCA technology, the gear modification is completed by first modifying the cutter and then using the cutter to cut the gear blank.
Cheng Wang, Shouren Wang, Gaoqi Wang
openaire +1 more source

