Evaluation of resistance form of different preparation features on mandibular molars
Aims: Resistance form of full metal-ceramic crown is an important feature that determines longevity of these restorations. This study evaluated the resistance form of full metal-ceramic prepared with four different design features. Materials and Methods:
Bajoghli Farshad +4 more
doaj +1 more source
Kedo-S Paediatric Rotary Files for Root Canal Preparation in Primary Teeth – Case Report [PDF]
Nickel-Titanium (Ni-Ti) instrument are widely used for root canal preparation in permanent tooth compared to primary teeth. Hand instrumentation technique remains the conventional method for root canal preparation in primary teeth.
Ganesh Jeevanandan
doaj +1 more source
In the fixed prosthesis process dental prosthesis treatment, the dentist needs to conceive the morphology of the tooth preparation and make numerous micro-adjustments by manual operation.
Sun Jian-Peng +5 more
doaj +1 more source
Tooth preparation for post-retained restorations [PDF]
Failure of root canal treatment and/or post crowns can be avoided in many cases if appropriate tooth preparation is carried out. This paper discusses the rationale for the timing of post placement following root canal treatment and appropriate methods for removal of gutta-percha prior to post space preparation.
Ricketts, D N J +2 more
openaire +3 more sources
Pink Tooth of Mummery in the Maxillary Left Canine after Fixed Partial Denture (FPD) Preparation
Pink tooth of Mummery is typically found after trauma. However, this case report describes an unusual occurrence of pink tooth in a 67-year-old Caucasian male after fixed partial denture (FPD) tooth preparation.
Eger V. Korolevsky +2 more
doaj +1 more source
A survey on intentional root canal treatment for crown and bridge among dental practitioners [PDF]
Introduction/Objective Crown and bridge restorations are commonly used by general dental practitioners to replace partially edentulous areas following operative or endodontic procedures.
Palaniappan Jaganbabu +2 more
doaj +1 more source
Application of digital design combined with 3D-printing technologies in dental autotransplantation
Objective To evaluate the therapeutic effect of dental autotransplantation with the application of digital design combined with 3D printing of donor tooth models and recipient alveolar fossa model preoperatively.
WANG Ling +6 more
doaj +1 more source
A Case Of Severe Dental Fluorosis With Porcelain Crown Restoration
Introduction: Anterior all-ceramic crown restorations were successfully achieved through a prosthetically driven protocol combining diagnostic wax-up-guided tooth preparation with digital verification via intraoral scanning, ensuring optimal ...
Libin Song, Jiansong Mei
doaj +1 more source
Accuracy of Direct and Indirect Data Acquisition Methods in Fixed Prosthodontics with Intraoral Scanners and Cone-beam Computed Tomography: An In Vitro Study [PDF]
Purpose: The purpose of this in vitro study was to evaluate and compare the accuracy of direct intraoral scanners (IOS) and indirect cone-beam computed tomography (CBCT) data acquisition methods in capturing tooth preparation data for restorative ...
Varun Keskar +4 more
doaj +1 more source
Introduction: Tooth preparation for full veneer crowns has to be a fine balance between conservation of remaining tooth structure and provision of sufficient thickness of restorative material.
Sandeep Singh +5 more
doaj +1 more source

