Results 31 to 40 of about 3,246,236 (222)
Behavior of High Strength Self Compacted Hollow Section Reinforced Concrete Beams under Pure Torsion
Tikrit Journal of Engineering Sciences, 2015 In this work, an experimental study has been conducted to investigate the behavior of high strength self-compacted concrete hollow beams under pure torsion. In this work, the beams were implemented and tested under pure torsion load. A total of six beams
Haneen Maad Mahdi
doaj +1 more source
Calibration of the torsional and lateral spring constants of cantilever sensors [PDF]
, 2014 Financial support from the EPSRC (EP/K000411/1) and the University of St. Andrews under an Impact Acceleration Account (EP/K503940/1) are gratefully acknowledged.A method suitable for the calibration of the spring constants of all torsional and lateral ...
Hähner, Georg +2 more
core +1 more source
An Experimental Study of Torsional Properties of Polyvinylchloride
Kurdistan Journal of Applied Research, 2017 In this research, an experimental study has been performed to investigate the mechanical properties through torsion testing of polyvinylchloride (PVC) polymer specimens.
Sarkawt Rostam +4 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.A numerical–experimental framework is developed for characterizing multi‐matrix fiber‐reinforced polymers (MM‐FRPs) combining epoxy and polyurethane matrices. Harmonic bending tests are integrated with finite element model updating (FEMU) to simultaneously identify elastic and viscoelastic material parameters.
Rodrigo M. Dartora +4 more
wiley +1 more source
Lateral Torsional Buckling Resistance of Horizontally Curved Steel I-Girders [PDF]
, 2015 The current design provisions (2006 edition of CSA-S6) for horizontally curved steel I-girders in the Canadian Highway Bridge Design Code are based on research conducted prior to the mid 1980's. Much research, experimental and numerical analysis, on
Rettie, Nolan J
core +1 more source
, 2021 Introduction: The aim of this study was to investigate the influence of mass and the polar moment of inertia on the torsional behavior of nickel-titanium rotary instruments to understand which parameter of cross-sectional design had a key role in terms ...
Zanza A. +11 more
core +1 more source
Advanced Engineering Materials, EarlyView.This article presents the design, modeling, and characterization of air‐pressure–actuated programmable vibroacoustic metamaterials (PVAMM). The study focuses on leveraging air pressure to dynamically tune resonance frequencies for effective noise attenuation.
William Kaal +2 more
wiley +1 more source
Advances in Mechanical Engineering, 2018 In present, the drilling industry have to face the reality of low oil and gas prices, fully mechanical vertical drilling tool is likely to become the best choice for vertical drilling in the future.
Lixin Li +4 more
doaj +1 more source
Investigation on using stiffness in Slotted web connection under cyclic load [PDF]
Journal of Structural and Construction Engineering, 2019 A lot of moment resisting steel frames were damaged, after Northridge earthquake. In these building, the usual rigid weld connection didn’t work properly and fielded.
Hamid Mirshekar, Seyed Roohollah Mousavi
doaj +1 more source
Effects of wall compliance on the laminar–turbulent transition of torsional Couette flow [PDF]
, 2003 Torsional Couette flow between a rotating disk and a stationary wall is studied experimentally. The surface of the disk is either rigid or covered with a compliant coating.
Ali, Reza +20 more
core +1 more source