Results 11 to 20 of about 101,710 (207)
Harmonic Assessment Based Adjusted Current Total Harmonic Distortion
Power systems suffer from harmonic distortion and extra ohmic losses associated with them. Moreover, all harmonic frequencies are mostly assumed to have the same effect on the system losses. However, the frequency‐dependency of the resistances should be taken into account, so that the apparent power and the power factor have to ...
Shady Abdel Aleem +2 more
doaj +5 more sources
This paper shows the implementation of the Moth–Flame Optimization algorithm in a Cascade-H multilevel inverter with five and seven levels to determine the optimal switching sequence of the inverter’s semiconductor devices.
Adolfo R. Lopez +12 more
doaj +2 more sources
Harmonic distortion is one of the disturbances that most affects the quality of the electrical system. The widespread use of power electronic systems, especially power converters, has increased harmonic and interharmonic emission in a wide range of ...
Angel Arranz-Gimon +3 more
doaj +2 more sources
Problem of Total Harmonic Distortion Measurement Performed by Smart Energy Meters
Currently, electricity is treated as commodity that should be delivered from a distributor to a consumer with a certain quality. The power quality is defined by the set of measures with specific limit values.
Kuwałek Piotr, Wiczyński Grzegorz
doaj +2 more sources
Total harmonic distortion of an asymmetric quasi-sinusoidal current [PDF]
This paper presents the correlation of factors that determine the quality of asymmetric quasi-sinusoidal output current and dynamic losses in the switches of the current generator circuit.
Grebennikov Vitaliy +2 more
doaj +3 more sources
Precision of the Sinefitting-Based Total Harmonic Distortion Estimator [PDF]
An analytical expression for the standard deviation of Total Harmonic Distortion (THD) estimation is derived. It applies to the case where the estimator uses sine fitting.
Alegria Francisco C.
doaj +2 more sources
Total Harmonic Distortion at Fault in RLC Load
<p>This paper focuses on the calculation of total harmonic distortion (THD) at various fault situations in case of RLC load. The faults are created by introducing heavy impedance of 1000 ohm, by blowing off the gate pulse at one of the terminals of the mosfet, and by introducing a line to ground fault. The Matlab based simulation has been done to
Pankaj Aswal +4 more
openaire +2 more sources
Harmonic distortion is one of the dominant factors limiting the overall signal-to-noise and distortion ratio of seismic-grade sigma-delta MEMS accelerometers. This study investigates harmonic distortion based on the multiple degree-of-freedom model (MDM)
Xuefeng Wang, Penghao Zhang, Shijin Ding
doaj +1 more source
This work presents a substantial improvement of the variables’ inclusion and interchange algorithm (VIIA) for capacitors placement that considers circuits with harmonic distortion.
Ignacio Perez Abril
doaj +1 more source
Studi Kualitas Energi Listrik Gedung Fakultas Teknik Universitas Bangka Belitung
One of the performances of the electric power system can be seen from the quality of electrical energy. In this study, the measurement of the quality of electrical energy was carried out using a power quality meter to obtain the values of current ...
Asmar Asmar, Wahri Sunanda
doaj +1 more source

