Results 151 to 160 of about 9,089,745 (325)
Solar Irradiance Variations on Active Region Time Scales [PDF]
The variations of the total solar irradiance is an important tool for studying the Sun, thanks to the development of very precise sensors such as the ACRIM instrument on board the Solar Maximum Mission.
Willson, R. C. +3 more
core
The graphical abstract summarizes a geographic information system (GIS)‐based synthesis of renewable energy resources in Northeastern Morocco, focusing on the Guercif‐Guilliz and Beni Snassen areas. It visually presents the spatial distribution of solar irradiation and wind energy potential derived from available datasets, alongside their relationship ...
Meryem Redouane +5 more
wiley +1 more source
Stabilization Strategies for Carbon Based Perovskite Solar Cells Under Light, Heat, and Humidity
Carbon‐based MA1−x(AVA)xPbI3/CsPbBr3 QD heterostructures fabricated under ambient conditions exhibit < 5% loss under ISOS‐D‐3 and reversible photo‐induced degradation, revealing the dual role of QDs in defect passivation and dynamic interfacial stabilization.
Emilie Planes +4 more
wiley +1 more source
An S‐scheme red phosphorus/BiVO4 heterojunction is presented, where red phosphorus served as the water reduction site, and BiVO4 functioned as the water oxidation site. Because it has a built‐in electric field that helps charge transfer and separation, red phosphorus/BiVO4 works very well in the photocatalytic overall water splitting process.
Guanman Liu +9 more
wiley +1 more source
Total Solar Irradiance Variability and the Solar Activity Cycle
It is suggested that the solar variability is due to the perturbed nature of the solar core and this variability is provided by the variability of the solar neutrino flux from the solar neutrino detectors i.e., Homestake, Superkamiokande, SAGE and GALLEX-GNO.
openaire +2 more sources
Polyelectrolytes represent a low‐cost and effective platform for tailoring charge extraction interfaces in inverted perovskite solar cells (PSCs). In this work, we introduce a protonated polyethyleneimine (PEI) layer (pH = 2) between the ITO electrode and the PTAA hole transport layer to increase the apparent work function of ITO by 0.066 eV and reduce
Aleksandra Furasova +10 more
wiley +1 more source
Ni–Zn–Ga Alloy for Weak Sunlight‐Driven Methanol Production From CO2 and H2O at Ambient Pressure
The Ni–Zn–Ga ternary alloy‐assisted photothermal CO2 hydrogenation system coupled with photovoltaic water splitting could convert CO2 and H2O into methanol with a production rate of 709 μmol g−1 h−1 under natural sunlight irradiation. ABSTRACT The sunlight‐driven artificial photosynthesis that converts CO2 and H2O into methanol is a promising approach ...
Linjia Han +9 more
wiley +1 more source
Initial Results of Aperture Area Comparisons for Exo-Atmospheric Total Solar Irradiance Measurements
In the measurement of exo-atmospheric total solar irradiance (TSI), instrument aperture area is a critical component in converting solar radiant flux to irradiance.
Fowler, Joel B. +3 more
core
Fluorescent Colored Passive Radiative Cooling Based on Carbon Dots for Cooling Power Recovery
We demonstrate colored passive radiative coolers consisting of a highly reflective porous ceramic base covered by an eco‐friendly luminescent carbon dot‐polymer composite, with two types of carbon dots enabling conversion of either ultraviolet or visible light, respectively.
Lin Liang +12 more
wiley +1 more source
Overview of Ru‐based photothermal catalysis from light harvesting to heat utilization. The performance of Ru‐based photothermal catalysts is governed by four interconnected energy‐utilization steps: light harvesting, heat generation, heat retention, and heat utilization.
Cong Wang +7 more
wiley +1 more source

