Results 21 to 30 of about 331,911 (292)
A mathematical model of critical jet heights causing droplets splashing in BOF steelmaking
Metalurgija, 2022 It is important to understand the physical interaction between top-blown oxygen jet and liquid bath in basic oxygen steelmaking furnaces (BOF). In this study, cold model experiments were carried out to investigate the cavity depth, diameter and the ...
D. Xu, B. Zheng, L. X. Guo, H. X. Pang
doaj
The complexity of recognizing minimally tough graphs [PDF]
, 2019 A graph is called $t$-tough if the removal of any vertex set $S$ that disconnects the graph leaves at most $|S|/t$ components. The toughness of a graph is the largest $t$ for which the graph is $t$-tough.
Katona, Gyula Y +2 more
core +3 more sources
Metals, 2018 To improve the weld zone properties of Advanced High Strength Steel (AHSS), quenching and partitioning (Q&P) has been used immediately after laser welding of a low-carbon steel. However, the mechanical properties can be affected for several reasons: (
Farnoosh Forouzan +3 more
doaj +1 more source
Influence of heat treatment on mechanical properties of steel
Research in Agricultural Engineering, 2004 This article concerns an influence of heat treatment on strength and toughness of steel. The partial results of tests on steel 12 042 are presented.
R. Chotěborský, M. Brožek
doaj +1 more source
Investigation of the effect of preload on the mechanical properties of fiber-reinforced geopolymer concrete [PDF]
مهندسی عمران شریف, 2022 Concrete may be loaded at an early age for a variety of reasons. This loading can have negative and sometimes destructive effects on the hardened properties of concrete.
A. Sadr Momtazi, K. Gholipour, R. Kohani
doaj +1 more source
Plastic pre-compression and creep damage effects on the fracture toughness behaviour of Type 316H stainless steel [PDF]
, 2014 The influence of inelastic damage in the form of plastic pre-strain and creep damage, on fracture toughness of Type 316H stainless steel has been examined.
Davies, C. M. +3 more
core +1 more source
Reinforcing Efficiency of Micro and Macro Continuous Polypropylene Fibers in Cementitious Composites
Applied Sciences, 2019 The effect of the microstructure of hydrophilic polypropylene (PP) fibers in the distribution of cracking associated with the strengthening and toughening mechanism of cement-based composites under tensile loading was studied.
Barzin Mobasher +4 more
doaj +1 more source
Influence of boron content on the fracture toughness and fatigue crack propagation kinetics of bainitic steels [PDF]
, 2016 The relatively good combination of high strength and ductility makes bainitic steels a candidate to replace many other steels in industrial applications. However, in service, ductility and strength are not up to standard requirements.
Cabrera Marrero, José M. +4 more
core +2 more sources
Rudarsko-geološko-naftni Zbornik, 2018 The circular diamond saw (CDS) is one of the major sawing machines in dimension stone processing plants. Predicting the performance of a circular diamond saw is very important to estimate the cost and the planning of the stone processing plants.
Masoud Akhyani +2 more
doaj +1 more source
Royal Society Open Science, 2023 The feeding apparatus of sea turtles comprises cornified keratinous rhamphothecae overlaying a bony rostrum. Although keratin is less stiff than the enamel of toothed animals, certain species of sea turtles are capable of withstanding large forces when ...
Danielle N. Ingle +3 more
doaj +1 more source