Results 31 to 40 of about 4,251,800 (292)
Sampling Random Transfer Functions [PDF]
42nd IEEE International Conference on Decision and Control (IEEE Cat. No.03CH37475), 2004 Recently, considerable attention has been paid to the use of probabilistic algorithms for analysis and design of robust control systems. However, since these algorithms require the generation of random samples of the uncertain parameters, their application has been mostly limited to the case of parametric uncertainty.
Constantino M. Lagoa +3 more
openaire +1 more source
Contribution analysis of vibration mode utilizing operational TPA
Mechanical Engineering Journal, 2016 Operational transfer path analysis (OTPA) calculates contributions of reference points to response point vibration by using only operational data.
Junji YOSHIDA, Koki TANAKA
doaj +1 more source
Linear and nonlinear identification of the carotid sinus baroreflex in the very low‐frequency range
Physiological Reports, 2022 Since the arterial baroreflex system is classified as an immediate control system, the focus has been on analyzing its dynamic characteristics in the frequency range between 0.01 and 1 Hz. Although the dynamic characteristics in the frequency range below
Toru Kawada +3 more
doaj +1 more source
Visualization of Medical Volume Data Based on Improved K-Means Clustering and Segmentation Rules
IEEE Access, 2021 Accurate extraction and visualization of the target features are important in medical visualization, allowing the user to get a meaningful view of their targets.
Ji Ma, Yazan Ahmad Muad, Jinjin Chen
doaj +1 more source
Touch scrolling transfer functions [PDF]
Proceedings of the 26th annual ACM symposium on User interface software and technology, 2013 Touch scrolling systems use a transfer function to transform gestures on a touch sensitive surface into scrolling output. The design of these transfer functions is complex as they must facilitate precise direct manipulation of the underlying content as well as rapid scrolling through large datasets.
Quinn, Philip +2 more
openaire +2 more sources
On the estimation of transfer functions
Automatica, 1985 This paper treats the close conceptual relationships between the three basic approaches to estimation of transfer functions of linear systems: frequency analysis, spectral analysis and time domain prediction error methods. The emphasis of this paper is put on the empirical transfer function estimate (ETFE), which is a direct extension of the frequency ...
openaire +1 more source
Advances in Electrical and Computer Engineering, 2011 Transfer function (TF) is an acknowledged method for power transformer mechanical faults detection. However the past published works mostly discovered how to specify the faults levels and paid less attention to detection of the type of faults using ...
RAHIMPOUR, E., VAKILIAN, M., BIGDELI, M.
doaj +1 more source
Applied Sciences, 2019 Identifying the cause of vehicle noise is a basic requirement for the development of low-noise vehicles. The tire pattern noise depends on the tire itself and causes complex and unpredictable sounds.
Sang-Kwon Lee +3 more
doaj +1 more source
Structural-Parametric Model of Electromagnetoelastic Actuator for Nanomechanics
Actuators, 2018 The generalized parametric structural schematic diagram, the generalized structural-parametric model, and the generalized matrix transfer function of an electromagnetoelastic actuator with output parameters displacements are determined by solving the ...
S. M. Afonin
doaj +1 more source
A Matrix Approach for Analyzing Signal Flow Graph
Information, 2020 Mason’s gain formula can grow factorially because of growth in the enumeration of paths in a directed graph. Each of the (n − 2)! permutation of the intermediate vertices includes a path between input and output nodes.
Shyr-Long Jeng +2 more
doaj +1 more source