Results 11 to 20 of about 47,277 (264)
Voltage Stability and Transient Symmetrical Fault Current Control of Voltage-Controlled MMCs [PDF]
This paper presents a design-oriented analysis on the voltage stability and the transient fault current limitation of voltage-controlled modular multilevel converter (MMC) with L-filters. First, a dual-loop voltage control based on the L-filter plant is systematically designed, where the upper limits of controller parameters to ensure the small-signal ...
Yingbiao Li +6 more
openaire +1 more source
Permanent magnet synchronous motor is widely used in industrial sites. In some cases,it is started softly by variable frequency converter and then switched to operate normally with power frequency.
ZHANG Zhihua +4 more
doaj +1 more source
Transient Voltage Stability Assessment Method based on gcForest
Abstract Aiming at the fact that the traditional method cannot quickly and accurately judge the power system transient voltage stability, and the deep neural network method needs many sample data sets and has a large number of hyperparameters, a power system transient voltage stability assessment method based on deep forest (gcForest) is
Sun Zhiyuan +5 more
openaire +1 more source
Under the influences of AC-DC coupling, uncoordinated network-source development, and new energies that fail to meet the demand of grid-related performance, power system stability is becoming a point of extreme gravity. The correlation characteristics of
WANG Bowen +5 more
doaj +1 more source
The proportion of the integrated converters using PSC (power synchronization control) in power systems is increasing year by year, but there is a lack of in-depth research on the transient synchronization stability.
XIANG Zhongming +6 more
doaj +1 more source
The proliferation of Photovoltaic (PV) generation has brought several changes in the transient stability analysis of power systems. The rotor angle dynamics based stability analysis used for synchronous generators may not be applicable for PV generators.
Indla Rajitha Sai Priyamvada +1 more
doaj +1 more source
Sram cell stability metric under transient voltage noise
Abstract The conventional way to analyze the robustness of an SRAM bit cell is to quantify its immunity to static noise. The static immunity to disturbances like process and mismatch variations, bulk static noise, supply ring offset, quasi static temperature changes are well characterized by means of the Static Noise Margin (SNM).
Vatajelu, Elena Ioana +3 more
openaire +3 more sources
Influence of DC-Bus Voltage on Synchronization Stability of Grid-Following Converters
With the increasing penetration of new energy sources and the development of new power systems, grid-following converter (GFL) plays a crucial role in maintaining the stability of power systems.
SI Wenjia, CHEN Junru, ZHANG Chenglin, LIU Muyang
doaj +1 more source
For high-proportion renewable energy sending-end power grids, various transient voltage instabilities including transient overvoltage, transient low voltage, delayed voltage recovery, repeated low voltage ride through, and sustained low voltage, are ...
Lei Wu, Pupu Chao, Weixing Li, Zhimin Li
doaj +1 more source
Models of a low voltage distribution network using a typical tertiary-structure solid state transformer (SST) for the integration of distributed generations (DGs) and a conventional low voltage distribution network integrated with DGs were established to
Sheng Li +3 more
doaj +1 more source

