Results 61 to 70 of about 84,868 (188)
Influence of a Hub-Groove on the Unsteady Losses of a Transonic Compressor Stage [PDF]
In this paper the influence of a non-symmetrical sidewall-contour on the flow field of an axial compressor is investigated. In earlier studies, carried out at the DLR Institute of Propulsion Technology in Cologne, it has been shown that it is ...
Nicke, Eberhard +3 more
core
Schematic showing a stretchable triboelectric nanogenerator based on interlocked wavy architectures that uses EGaIn microflower‐embedded PVDF‐TrFE and Nylon‐6 nanofiber membranes. The multi‐petaled, electron‐rich EGaIn microflowers enhance interfacial polarization and capacitance, while the interlocked wavy architecture enlarges the effective contact ...
Qianqian Xu +12 more
wiley +1 more source
Atomic Tuning of Metal‐Support Interactions for Pathway‐Selective CO2 Photoreduction on TiO2
Single‐atom Fe and Cu catalysts anchored on TiO2 steer photocatalytic CO2 reduction toward distinct pathways. Fe sites favor rapid *CO desorption and selective CO formation, whereas Cu sites stabilize *CHO intermediates, enabling deep reduction and C─C coupling. Combined spectroscopy and DFT calculations reveal how metal–support interactions and oxygen
Dongyun Kim +13 more
wiley +1 more source
To address the influence of the high-altitude low Reynolds number effect on compressors, this study investigates an axial transonic compressor through a numerical approach based on the Reynolds-averaged Navier–Stokes equations.
Yuhui Huang, Qin Li, Yancheng You
doaj +1 more source
A rigid‑flexible integrated CO depot is engineered by embedding rigid COFQDs into a flexible ECM gel network. The rigid framework enables high‑capacity CO storage and sonodynamic bacterial killing, while the flexible ECM gel controls sustained CO release, collectively eradicating multidrug‑resistant infection and promoting scarless healing.
Baohong Sun +13 more
wiley +1 more source
This study elucidates the phase transition pathway of surface‐engineered perovskite films. During spin‐coating, n = 1 2D perovskite dominantly forms, while subsequent annealing drives OA+ release and induces conversion to higher n‐value 2D phases.
Yajie Yang +12 more
wiley +1 more source
Transonic compressors encounter significant challenges from shock formations due to high-speed supersonic blade tips, particularly at high altitudes where lower Reynolds numbers result in laminar boundary layer separation and increased mixing losses ...
Ahmed H. Hanfy +3 more
doaj +1 more source
Influence of blade geometry on secondary flow development in a transonic centrifugal compressor
Due to the increasing demand for higher efficiencies of centrifugal compressors, numerical optimization methods are becoming more and more relevant in the design process.
Moritz Mosdzien +4 more
doaj +1 more source
3D unsteady flow in oscillating compressor cascade [PDF]
An experimental and computational study has been carried out to enhance current understanding of three dimensional (3D) cascade aeroelastic mechanisms. 3D unsteady pressure data produced during executing this project is the first-of-its-kind, which can ...
Yang, Hui
core
Chemical vapor deposition produces large‐grain, phase‐pure CsPbBr3 films (grains up to 35 µm) with Drude‐like terahertz photoconductivity and twofold higher carrier mobility versus spin‐coated references. These microstructural advances translate into photodetectors with a detectivity of 8.4 × 1012 Jones, dark current below 1 pA cm−2, X‐ray sensitivity ...
Roel Vanden Brande +14 more
wiley +1 more source

