Results 111 to 120 of about 40,878 (218)
Advances in Materials Science and Engineering, 2019 Corn stalk fibre reinforced nonasbestos environment-friendly friction composite materials have been fabricated, and their physical, mechanical, and tribological properties are characterized.
Zhen-yu Wang, Jie Wang, Yun-hai Ma
doaj +1 more source
steel research international, EarlyView.Tool steels tested under injection molding conditions with glass‐fiber‐reinforced polymers, revealing how viscous dissipation drives hardness loss, even in PM grades. A sharp rise in wear with increasing injection volume rate and thermomechanical load uncovers striking material differences.
David Zidar +3 more
wiley +1 more source
Multi-Sensor Fusion and Deep Learning for Predictive Lubricant Health Assessment
LubricantsLubricating oil degradation directly impacts friction coefficient, wear rate, and lubrication regime transitions, making precise health quantification essential for predictive tribological maintenance.
Yongxu Chen +5 more
doaj +1 more source
steel research international, EarlyView.Laser powder bed fusion of JIS SKD61 tool steel is systematically optimized using a Taguchi design and ANOVA. Hatch spacing and layer thickness are identified as dominant parameters controlling surface roughness and tensile strength. Subsequent tempering at 600°C improves microstructural stability and mechanical performance, enabling high‐density SKD61
Masrurotin Masrurotin +4 more
wiley +1 more source
The wear behaviour of ion implanted biomaterials [PDF]
, 2003 The tribological performance of biomaterials used for artificial joints is of much importance, and require low coefficients of friction, resistance to wear and the ability to withstand many millions of cycles under a multitude of loading regimes ...
Boampong, Derrick Kwadwo
core
steel research international, EarlyView.Niobium cathodic cage duplex treatment is applied to VP20TS steel to evaluate the influence of surface roughness and temperature on coating performance. Results show that higher temperatures promote thicker nitride layers and increased microhardness, while finer surface preparation enhances adhesion and wear resistance, revealing optimal conditions for
Alan Bruno Costa Cardoso +6 more
wiley +1 more source
An overview of laser surface modification of die steels [PDF]
, 2008 In recent years, surface modification using advanced heat source like laser has been replacing the conventional methods to produce amorphous microstructure via rapid solidification.
Brabazon, Dermot +3 more
core
LubricantsThe properties of composite materials depend not only on the composition but also on the distribution and orientation of the fillers, i.e., on the internal material architecture.
Alois K. Schlarb +4 more
doaj +1 more source
Nonthermal plasma approaches for combating implant‐associated infections: A compendious review
VIEW, EarlyView.Implant‐associated infections pose serious clinical challenges. Non‐thermal plasma (NTP) modifications overcome this bottleneck in distinct ways relative to traditional sterilization methods. Gas‐phase plasmas generate highly energetic species, UV radiation and reactive oxygen/nitrogen species (RONS), which alter the implant surface properties.
A. M. Trimukhe +8 more
wiley +1 more source
Microstructure and tribological behaviour of Al2O3 particle-reinforced aluminum alloy composite: A comparative study [PDF]
, 2014 This paper presents the tribological behaviour of aluminum 2124 alloy reinforced with 10 wt.% Al2O3 particles, produced by powder metallurgy (PM) method. A comparison is made between MMCs and its coated MMCs generated by anodic oxidation method under the
core