Results 311 to 320 of about 253,700 (370)
Inorg Chem FrontSome of the next articles are maybe not open access.
Related searches:
Related searches:
ChemSusChem, 2020
The current progress in the advancement of energy storage devices is the most important factor that will allow the scientific community to develop resources to meet the global energy demands of 21st century.
P. Shinde, S. Jun
semanticscholar +1 more source
The current progress in the advancement of energy storage devices is the most important factor that will allow the scientific community to develop resources to meet the global energy demands of 21st century.
P. Shinde, S. Jun
semanticscholar +1 more source
Sequential oxidation and reduction of tungsten/tungsten oxide
Thin Solid Films, 2015Abstract The reduction of oxide films on the surface of tungsten was studied. The oxide films were created by briefly exposing smooth W foils to oxygen plasma generated using a microwave discharge at 500 W and an oxygen pressure of 40 Pa. Oxidation resulted in the formation of a WO3 film with a thickness of approximately 1700 nm. The oxidised samples
Vesel, Alenka +2 more
openaire +4 more sources
ChemInform, 2003
AbstractFor Abstract see ChemInform Abstract in Full Text.
T. Okamura, N. Ueyama
openaire +1 more source
AbstractFor Abstract see ChemInform Abstract in Full Text.
T. Okamura, N. Ueyama
openaire +1 more source
Electrochemical preparation of tungsten, tungsten carbide and cemented tungsten carbide
Mineral Processing and Extractive Metallurgy, 2013Tungsten is conventionally made by the reduction of tungsten oxide with hydrogen, tungsten carbide by the reaction of tungsten with carbon and cemented tungsten carbide by the sintering together of tungsten carbide with a metal, usually cobalt. This paper reports the electrochemical preparation of tungsten, tungsten carbide and cemented tungsten ...
D.-H. Tran-Nguyen, D. Jewell, D. J. Fray
openaire +2 more sources
ACS Applied Materials and Interfaces, 2019
Ni-rich NCM-based positive electrode materials exhibit appealing properties in terms of high energy density and low cost. However, these materials suffer from different degradation effects, especially at their particle surface.
D. Becker +8 more
semanticscholar +1 more source
Ni-rich NCM-based positive electrode materials exhibit appealing properties in terms of high energy density and low cost. However, these materials suffer from different degradation effects, especially at their particle surface.
D. Becker +8 more
semanticscholar +1 more source
Tungsten and Tungsten Alloy Products
1999Besides tungsten metal, only those alloys which were described in Chapter 6 are treated in this chapter. Alloys produced by melting metallurgy as well as the cemented carbides hardmetals) and their application are treated in Chapters 8 and 9, respectively.
Wolf-Dieter Schubert, Erik Lassner
openaire +2 more sources
2007
In animal models, almost half of an ingested dose of tungsten in the form of a soluble salt and a third of a deposited inhaled aerosol of tungstic oxide were reported to be rapidly absorbed. Most of the absorbed tungsten was rapidly excreted in the urine.
Per E. Leffler, George Kazantzis
openaire +3 more sources
In animal models, almost half of an ingested dose of tungsten in the form of a soluble salt and a third of a deposited inhaled aerosol of tungstic oxide were reported to be rapidly absorbed. Most of the absorbed tungsten was rapidly excreted in the urine.
Per E. Leffler, George Kazantzis
openaire +3 more sources
ChemInform Abstract: Dithiocarbamates of Tungsten(III) and Tungsten(IV).
ChemInform, 1987AbstractThe dimeric tris(dialkyldithiocarbamato)‐W(III) complexes (III) and the monomeric tetrakis(dialkyldithiocarbamato)‐W(IV) complexes (IV) are prepared by photochemical oxidative decarbonylation of the starting complex (I) as shown.
W. Earle Waghorne +3 more
openaire +3 more sources