Results 71 to 80 of about 128,770 (269)
Ferroelectric Quantum Dots for Retinomorphic In‐Sensor Computing
This work has provided a protocol for fabricating retinomorphic phototransistors by integrating ferroelectric ligands with quantum dots. The resulting device combines ferroelectricity, optical responsiveness, and low‐power operation to enable adaptive signal amplification and high recognition accuracy under low‐light conditions, while supporting ...
Tingyu Long +26 more
wiley +1 more source
Effects of Reinjection on Flow Field of Open Jet Automotive Wind Tunnel Test Section
The distributions of axial static pressure coefficient and flow fluctuation in the test section which affect aerodynamic measurement in an open jet wind tunnel is presented.
Q. Li +6 more
doaj
Using the monitoring temperature field data from the flat steel box girder, the time histories of temperature data and temperature difference data are investigated using the extreme value analysis method.
Jun Yang +3 more
doaj +1 more source
Review on water disaster prevention of tunnels
Water disaster in tunnel engineering is a persistent problem in tunnel field. To address this issue, this paper summarizes the literature of water disaster prevention in tunnel engineering, defines the problem of water disaster in tunnel engineering ...
WANG Fuming +4 more
doaj +1 more source
Strain Engineering of Magnetoresistance and Magnetic Anisotropy in CrSBr
Biaxial compressive strain significantly enhances magnetoresistance and critical saturation fields in thin flakes of the 2D magnet CrSBr, along all three crystallographic axes. First‐principles calculations link these effects to strain‐induced increases in exchange interactions and magnetic anisotropy.
Eudomar Henríquez‐Guerra +19 more
wiley +1 more source
The seminal transformation of a 2D‐COF (SURFCOF‐IMDEA1) into a 2D porous COF (SURFCOF‐IMDEA2) on Au(111) by a sequential C‐C coupling and ladderization triggered by thermal annealing steps at increasing temperatures is reported. Abstract The development of covalent organic frameworks (COFs) is currently a primary objective in materials science, taking ...
Ana Barragán +11 more
wiley +1 more source
Rapid alignment evaluation method for prefabricated arch bridges based on virtual trial assembly
Geometric dimension inspection and overall alignment evaluation of arch ribs remain challenging during the manufacturing and installation of prefabricated arch bridges. Enabled by three-dimensional laser scanning for rapid and accurate capture of complex
Jinyu Zhu +6 more
doaj +1 more source
Assessment of Rainfall Variability over Karnataka state in India
Karnataka state situated in the southern part of India is surrounded by a long coast line and western ghat mountain regions on the western side. The rainfall distribution shows a large variability in different parts of the state.
Krushna Chandra Gouda +3 more
doaj +1 more source
Kelvin Probe Force Microscopy in Bionanotechnology: Current Advances and Future Perspectives
Kelvin probe force microscopy (KPFM) enables the nanoscale mapping of electrostatic surface potentials. While widely applied in materials science, its use in biological systems remains emerging. This review presents recent advances in KPFM applied to biological samples and provides a critical perspective on current limitations and future directions for
Ehsan Rahimi +4 more
wiley +1 more source
The long span deck type concrete filled steel tube (CFST) arch bridge encounters considerable safety risks under intricate traffic loads because to its extensive span, elevated columns, and pronounced dynamic sensitivity.This study utilizes the Wujiang ...
Yong Zeng +4 more
doaj +1 more source

