Results 311 to 320 of about 1,014,229 (401)

Interfacial Chemistry Behind Damage Monitoring in Glass Fiber‐Reinforced Composites: Attempts and Perspectives

Polymer Composites, EarlyView.
Role of the modifications at the interface in glass fiber reinforced composites for damage monitoring. ABSTRACT Glass Fiber Reinforced Polymers (GFRPs) are widely used in structural applications but degrade over time due to internal damage. Structural Health Monitoring (SHM) enables early damage detection, improving reliability and reducing maintenance
Marta Colombo, Silvia Mostoni, Giulia Fredi, Carol Rodricks, Gerhard Kalinka, Massimiliano Riva, Andrea Vassallo, Barbara Di Credico, Roberto Scotti, Michele Zappalorto, Massimiliano D'Arienzo   +10 more
wiley   +1 more source

Assessment of the water and energy nexus in the energy supply subsystem of water stressed countries like Iran. [PDF]

Sci Rep
Vahabzadeh M, Molajou A, Variani HA, Afshar A.   +3 more
europepmc   +1 more source

Sensitivity Analysis of the Elastic Properties of Graphene/Fiber‐Reinforced Nanocomposites

Polymer Composites, EarlyView.
The formation of graphene/fiber‐reinforced nanocomposites. ABSTRACT This study offers a detailed sensitivity analysis of the elastic behavior of graphene/fiber‐reinforced nanocomposites using a multiscale micromechanical modeling framework. It focuses on key elastic properties, which are the longitudinal modulus (E11$$ {E}_{11} $$), transverse modulus (
Ranganai Tawanda Moyo, Pavel Yaroslavovich Tabakov, Sibusiso Moyo   +2 more
wiley   +1 more source

Real-time data fetching approach for performance evaluation of a DFIG wind power generation system using an IoT-enabled wind emulator. [PDF]

Sci Rep
Sitharthan R, Rajesh M, Kumar RS, Dhanabalan SS.   +3 more
europepmc   +1 more source

Water‐Borne Erosion of Reinforced Polymer Composites: Application to Shallow Offshore Marine Environment

Polymer Composites, EarlyView.
Comparison of experimental and model‐predicted erosion rates for carbon fibre‐reinforced polymer (CFRP) and glass fibre‐reinforced polymer (GFRP) under low‐velocity (2 m/s) and at varying angles and sand concentrations (0.0, 0.05, 0.4 g/L). The results demonstrate good agreement between experimental data and model predictions across different erosive ...
Ali Al‐Darraji, Christopher Lagat, Thaneshan Sapanathan, Peter Butt, Ibukun Oluwoye   +4 more
wiley   +1 more source

Solar-assisted tri-generation system with LCPV‑CPC and small-scale gas turbine for year-round clean energy in hot-dry climates. [PDF]

Sci Rep
Ben Hamida MB, Rasheed RH, Singh NSS, Taghavi M.   +3 more
europepmc   +1 more source

Prediction of Cure‐Induced Wrinkles Aimed at the Manufacturing of Large Wind Turbine Blades

Polymer Composites, EarlyView.
The step‐wise progression of the development of cure‐induced wrinkles. Before curing, at room temperature the laminate is resting at the mould face. In the next step, the wrinkle is developing due to thermal gradients. At the end of curing, the composite has cooled down and the undulation is left in, byt the increase in resin stiffness across the ...
Jesper K. Jørgensen, Lars P. Mikkelsen, Vincent K. Maes   +2 more
wiley   +1 more source

Pulmonary Air Embolism Caused by an Air Turbine During Oral Surgery Under General Anesthesia: A Case Report. [PDF]

Int Med Case Rep J
Abe S, Wakamatsu K, Takahashi K, Sato H, Yoshida K, Yamazaki S, Kawaai H.   +6 more
europepmc   +1 more source

Eksperimentalna istraživanja na fizikalnom modelu Peltonove turbine

, 2017
Stjepan Komljenović, Elvis Žic, Saša Laloš   +2 more
openalex   +1 more source

Rheological Properties of Polyether Ether Ketones Containing Multi‐Walled Carbon Nanotubes

Polymer Engineering &Science, EarlyView.
Rheology, Melt Flow, and Spinnability of PEEK‐MWCNT Melts After Compounding. ABSTRACT In this study, the rheological and melt‐flow behavior of polyether ether ketone (PEEK) filled with multi‐walled carbon nanotubes (MWCNTs) was investigated to evaluate its melt‐spinnability.
Toty Onggar, Chokri Cherif
wiley   +1 more source