Results 101 to 110 of about 121,827 (324)
STUDI PENGARUH JUMLAH SUDU TERHADAP UNJUK KERJA SAVONIUS WATER TURBINE PADA ALIRAN AIR DALAM PIPA
Rotor: Jurnal Ilmiah Teknik Mesin, 2016 Rainwater, flowed through a pipe, has potential energy that can be used to drive a turbine coupled with generator. Savonius water turbine with horizontal axis is used here as the turbine.
Imron Hamzah +2 more
doaj
Polymer Composites, EarlyView.Role of the modifications at the interface in glass fiber reinforced composites for damage monitoring. ABSTRACT Glass Fiber Reinforced Polymers (GFRPs) are widely used in structural applications but degrade over time due to internal damage. Structural Health Monitoring (SHM) enables early damage detection, improving reliability and reducing maintenance
Marta Colombo +10 more
wiley +1 more source
Advances in Mechanical Engineering, 2018 The application of vertical axis wind turbine is suitable in a low wind speed environment. Nevertheless, vertical axis wind turbine with kenaf turbine blade will promote an additional green concept by utilising biocomposite materials.
A Hamdan, F Mustapha, MTH Sultan
doaj +1 more source
Sensitivity Analysis of the Elastic Properties of Graphene/Fiber‐Reinforced Nanocomposites
Polymer Composites, EarlyView.The formation of graphene/fiber‐reinforced nanocomposites. ABSTRACT This study offers a detailed sensitivity analysis of the elastic behavior of graphene/fiber‐reinforced nanocomposites using a multiscale micromechanical modeling framework. It focuses on key elastic properties, which are the longitudinal modulus (E11$$ {E}_{11} $$), transverse modulus (
Ranganai Tawanda Moyo +2 more
wiley +1 more source
Aerodynamic investigation of an air-cooled axial-flow turbine. Part 2: Rotor blade tip-clearance effects on overall turbine performance and internal gas flow conditions: Experimental results and prediction methods [PDF]
Total turbine blade performance was investigated while changing the blade tip clearance in three ways. The internal flow at the moving blade outlet point was measured. Experimental results were compared with various theoretical methods.
Inoue, S. +5 more
core +1 more source
Analisis Performansi Turbin Angin Poros Horisontal Model Double Rotor Contra Rotating Dengan Posisi Rotor Saling Berhimpitan [PDF]
, 2015 The contra rotating wind turbine is a horizontal axis turbine which has two shaft rotating in opposite directions on the same axis, and it can work at low wind speeds. In general, the performance of the wind turbine are affected by several factors, which
Bere, F. (Fredrikus) +2 more
core
Polymer Composites, EarlyView.Comparison of experimental and model‐predicted erosion rates for carbon fibre‐reinforced polymer (CFRP) and glass fibre‐reinforced polymer (GFRP) under low‐velocity (2 m/s) and at varying angles and sand concentrations (0.0, 0.05, 0.4 g/L). The results demonstrate good agreement between experimental data and model predictions across different erosive ...
Ali Al‐Darraji +4 more
wiley +1 more source
FluidsThe leading-edge erosion of a wind turbine blade was tested using a whirling arm rain erosion tester, whose rotation rate is considerably higher than that of a full-scale wind turbine owing to the scale effect.
Nobuyuki Fujisawa, Hirokazu Kawabata
doaj +1 more source
Turbine blade tip durability analysis [PDF]
An air-cooled turbine blade from an aircraft gas turbine engine chosen for its history of cracking was subjected to advanced analytical and life-prediction techniques.
Laflen, J. H. +2 more
core +1 more source