Results 81 to 90 of about 121,827 (324)
Advanced design and optimization of wind turbines based on turbine theories [PDF]
, 2019 A review of wind turbine technology showed that many flaws in both the flow models and computations are involved in the traditional fundamentals. While traditional methods for design and computation are all based on the airfoil theory, a new method based
Zhang, Zhengji
core +1 more source
Energy Science &Engineering, EarlyView.This paper aims to provide a robust design approach for HAWTs operating in shear flow. This study fills a critical research gap by integrating BEM and vortex theories for blade design in non‐homogeneous inflow conditions. The authors of the paper made an effort to develop and test an experimentally unsophisticated model of a turbine working in shear ...
Agnieszka Dorota Woźniak +2 more
wiley +1 more source
Design and Analysis of Gas Turbine Blade with Cooling
EAI Endorsed Transactions on Energy Web, 2018 The turbine inlet temperature in advanced gas turbine engine is very high and it is above the melting point of blade material. In this project radial convective cooling method is used.
S. Dhivya, A. Karthikeyan
doaj +1 more source
Laser-optical blade tip clearance measurement system [PDF]
A laser-optical measurement system was developed to measure single blade tip clearances and average blade tip clearances between a rotor and its gas path seal in rotating component rigs and complete engines.
Barranger, J. P., Ford, M. J.
core +1 more source
Second‐Order Between‐Supplier Learning
Journal of Operations Management, EarlyView.ABSTRACT Substantial empirical evidence shows that suppliers in emerging economies can enhance their technological capabilities through direct learning from technologically advanced foreign competitors. However, suppliers in emerging markets may struggle to learn directly from knowledge about competitors’ products that are not widely available on the ...
Lisha Liu, Xianwei Shi, Guangzhi Shang
wiley +1 more source
Measurements of Strain on 310 mm Torque Converter Turbine Blades
International Journal of Rotating Machinery, 2004 An automotive torque converter was tested in order to determine the effect of converter operating condition and turbine blade design on turbine blade strain in the region of the inlet core tab restraint.
P. O. Sweger +2 more
doaj +1 more source
Material Selection for Gas Turbine Blade Coating Using GRANTA Material Selector [PDF]
, 2015 This paper presents the selection of suitable candidate materials for thermal barrier coating of gas turbine blade using GRANTA software. There have been reported cases of gas turbine blade failure in service due to the extreme service conditions.
Abioye, Abiodun A. +6 more
core +1 more source
Limnology and Oceanography: Methods, EarlyView.Abstract Acoustic cameras, or imaging sonars, are often used to monitor marine energy sites in regions where the water is too dark or turbid for optical sensing. To do so more effectively, scientists are investigating automated detection methodologies to use on these data.
Theodore Nowak +2 more
wiley +1 more source
AERODYNAMIC ANALYSIS AND EXPERIMENTAL TEST FOR 4-BLADED VERTICAL AXIS WIND-TURBINE USING LARGE-EDDY SIMULATION (LES) TURBULENCE MODEL [PDF]
, 2012 G.J. Ryu +3 more
openalex +1 more source
Laser &Photonics Reviews, EarlyView.This review examines how optical coherence tomography transforms industrial inspection by delivering real‐time, micrometer‐resolution, depth‐resolved imaging. It surveys applications across display manufacturing, thin films, microelectronics, laser processing, and coatings, evaluates performance against conventional techniques, and highlights emerging ...
Nipun Shantha Kahatapitiya +7 more
wiley +1 more source