Results 101 to 110 of about 1,709 (217)

The Aero-Thermodynamic Possibilities of Increasing Turbocharging Efficiency

, 2014
Turbocharging is a basic possibility to increase the utilization of reciprocating internal combustion engines. It can be stated that reciprocating engines of more than 100kW nominal power are oftenequipped with turbochargers and in most of the cases they
Pásztor, Endre
core   +1 more source

Experimental investigation into the pulsating flow performance of a turbocharger turbine in the closed and open waste-gate region

, 2010
Nowadays, turbocharging is considered as a key technology for reducing CO2 emissions in downsized automotive engines. However, more information is still required on compressor and turbine behaviour when working under unsteady flow conditions.
CAPOBIANCO, MASSIMO, MARELLI, SILVIA
core   +1 more source

Development and testing of a HD diesel engine with two-state turbocharging

, 2000
A research project was carried out in which a DAF engine was equipped with a two-stage turbocharging system. Objectives were to investigate an engine concept with very high BMEP (25-30 bars), maintaining acceptable emissions and fuel consumption, while ...
Sturm, W.L., Kruithof, J.
core  

Development of an analytical model to evaluate the effect of the ported shroud on centrifugal compressors

Green Energy and Intelligent Transportation
Extending the operational range of centrifugal compressors is strategically vital for turbocharging internal combustion engines, particularly in enhancing efficiency and expanding operational capabilities.
Carlo Cravero, Philippe Joe Leutcha, Davide Marsano   +2 more
doaj   +1 more source

Turbocharging of marine diesel engines

, 2018
U ovom radu su opisani sustavi turbonabijanja brodskih četverotaktnih i dvotaktnih dizelskih motora. Povećanje tlaka zraka korištenog za ispiranje i izgaranje uvelike je doprinijelo rastu snaga i korisnosti motora, kao i smanjivanju dimenzija istog ...
Segarić, Matija
core  

Turbocharger Aero-Thermal Performance under Realistic Flow Conditions: Pulsating Flow and Heat Transfer Considerations [PDF]

, 2017
Differences between turbocharger performance on an engine and on a gas stand have been observed throughout decades of turbocharging studies. These differences have been attributed, in part, to various phenomena, the most important of which include heat ...
Pesiridis, A
core  

Paper 6: Turbocharging the Automotive Two-Stroke Cycle Engine

, 1965
The paper deals with the problems of turbocharging the two-stroke cycle engine. Obtaining a sufficiently rapid drop in the pressure of the cylinder contents after exhaust port opening is chiefly dependent on obtaining a high turbocharger efficiency ...
D. W. Tryhorn
core   +1 more source

Impacts of the New Worldwide Light-Duty Test Procedure on Technology Effectiveness and China's Passenger Vehicle Fuel Consumption Regulations. [PDF]

Int J Environ Res Public Health, 2021
Chen K, Zhao F, Liu X, Hao H, Liu Z.
europepmc   +1 more source

Highly turbocharging a restricted two cylinder small engine: turbocharger development

, 2007
This paper describes the turbocharger development of a restricted 430 cm3 odd firing two cylinder engine. The downsized test engine used for development was specifically designed and configured for Formula SAE, SAE’s student Formula race-car competition.
Watson, Harry, Attard, William, Konidaris, Steven   +2 more
core  

INNOVATION IN COHESIVE STOCK ECU TUNING AND TURBOCHARGING [PDF]

, 2016
Cutting edge business autos have been outfitted with Engine Control Unit (ECU) which permits more exact and precise running of an engine. ECU controls the measure of fuel infused, start timing A/F proportion with input from different sensors.
C, Dr. Perisamy.; Professor, Department of Mechanical Engineering, BITS Pilani, Dubai Campus, United Arab Emirates, Singh, Jasjeev; BE-Student, Department of Mechanical Engineering, BITS Pilani, Dubai Campus, United Arab Emirates   +1 more
core