Results 161 to 170 of about 113,224 (304)

Recurrent Hypothermia and Autonomic Dysfunction Secondary to Shapiro Syndrome

Annals of Clinical and Translational Neurology, EarlyView.
ABSTRACT A 44‐year‐old man presented with recurrent hypothermia, diaphoresis and hypertension. Extensive investigation for infectious, inflammatory, metabolic and endocrine aetiologies was negative. MR scan of the brain demonstrated no lesions but revealed callosal dysgenesis, consistent with Shapiro syndrome.
Naveen Kumar, Jeremy Johnson, Susanne Watkins, Eoin Mulroy   +3 more
wiley   +1 more source

Experimental Evaluation of 100Cr6 Steel Microindented Surfaces Under Lubricated Nonconformal Point Contacts

Advanced Engineering Materials, EarlyView.
The tribological behavior of 100Cr6 steel spheres textured via Vickers microindentation is evaluated under lubricated sliding by varying both dimple size and density. Fine and dense textures significantly reduce friction across all lubrication regimes, while large dimples increase it.
Farideh Davoodi, Pasquale Guglielmi, Gianfranco Palumbo, Giuseppe Carbone   +3 more
wiley   +1 more source

Optimization strut-based fuel injection using multi-step hydrogen jets and air-assisted mixing in supersonic flow. [PDF]

Sci Rep
Houria ZB, Hajlaoui K, Aminian SA, Musa VA, Sadeq AM, Shaban M, Aich W, Kriaa K.   +7 more
europepmc   +1 more source

Electrochemical Evaluation of Compressed Selective Laser Melted AlSi7Mg and AlSi10Mg Alloys in Chloride Environment

Advanced Engineering Materials, EarlyView.
The corrosion performance of AlSi7Mg and AlSi10Mg alloys produced through selective laser melting (SLM) was examined under compressive stress in a chloride environment. Electrochemical analyses, including open‐circuit potential (OCP), potentiodynamic polarization (CPP), and electrochemical impedance spectroscopy (EIS), were complemented by scanning ...
Femi John Akinfolarin, Samson Dare Oguntuyi, Peter Apata Olubambi   +2 more
wiley   +1 more source

Engineering Biomimetic Nanoparticle Performance Through Fabrication Method Selection: Turbulent Jet Mixing, Microfluidics, and Extrusion. [PDF]

Small Methods
Elizarov I, Mhajne R, Vizenblit O, Zinger A.   +3 more
europepmc   +1 more source

Innovative Processing of Compacted Waste Aluminum Alloy Powders via Controlled Remelting and Solidification

Advanced Engineering Materials, EarlyView.
This study demonstrates an efficient recycling route for out‐of‐spec AlSi10Mg atomized powders through compaction and arc remelting followed by suction casting. By correlating compaction load, cooling rate, and resulting microstructure, we show that intermediate pressures (50–80 kN) and rapid cooling refine dendrites, reduce porosity, and enhance ...
Mila Christy de Oliveira, Marcella Gaute Cavalcante Xavier, Abdoul‐Aziz Bogno, Piter Gargarella, José Eduardo Spinelli   +4 more
wiley   +1 more source

Investigation of Vortex-Driven Mixing in Hydrogen-Ammonia Low Pressure Direct Injection. [PDF]

ACS Omega
Zhang A.
europepmc   +1 more source

Zein‐Based Adhesives: Sustainable Extraction and Application in Bioadhesive Technologies

Advanced Engineering Materials, EarlyView.
Zein is extracted from corn gluten meal using a simple and scalable process with high yield (~90%). The resulting protein is applied in bioadhesives modified with Ca2+ and Fe3+ ions, exhibiting substrate‐dependent adhesion. The findings demonstrate competitive bonding performance and highlight the role of ionic interactions in tuning adhesion ...
Paula Bertolino Sanvezzo, Daniela Winsley Valereto Friozi, Vinícius de Oliveira, Marcia Cristina Branciforti   +3 more
wiley   +1 more source

Advances in Modelling Radiative Transfer, Heat Storage and Turbulent Transport to Evaluate CO₂, Heat and Water Fluxes Over Broad-Leaved Forests: The CanVeg2 Model. [PDF]

Glob Chang Biol
Béland M, Bonan GB, Meyers TP, Munger JW, Kobayashi H, Baldocchi D.   +5 more
europepmc   +1 more source

Mixing, transport and turbulence modulation in solid suspensions : study and modelling

, 2017
The transport of particles by turbulent flows is ubiquitous in nature and industry. It occurs in planet formation, plankton dynamics and combustion in engines. For the dispersion of atmospheric pollutants, traditional predictive models based on eddy diffusivity cannot accurately reproduce high concentration fluctuations, which are of primal importance ...
openaire   +1 more source