Results 11 to 20 of about 25,623 (209)
Effect of water storage on ultimate tensile strength and mass changes of universal adhesives. [PDF]
J Clin Exp Dent, 2017 The aim of the present study was to evaluate the influence of water storage on micro tensile strength (µTS) and mass changes (MC) of two universal adhesives.10 disk-shaped specimens were prepared for each adhesive; Scotchbond Universal (SCU) All-Bond Universal (ABU) and Adper Single Bond 2 (SB2).
Bahrololumi N +5 more
europepmc +4 more sources
Optimization and Prediction of Ultimate Tensile Strength in Metal Active Gas Welding. [PDF]
ScientificWorldJournal, 2015 We investigated the effect of welding parameters on ultimate tensile strength of structural steel, ST37‐2, welded by Metal Active Gas welding. A fractional factorial design was used for determining the significance of six parameters: wire feed rate, welding voltage, welding speed, travel angle, tip‐to‐work distance, and shielded gas flow rate.
Ampaiboon A, Lasunon OU, Bubphachot B.
europepmc +5 more sources
Linear Dimensional Change and Ultimate Tensile Strength of Polyamide Materials for Denture Bases [PDF]
Polymers, 2021 Bozhana Chuchulska, Stefan Zlatev
exaly +2 more sources
A New Prediction Method for the Ultimate Tensile Strength of Steel Alloys with Small Punch Test [PDF]
Materials, 2018 JOSÉ Calaf-Chica +2 more
exaly +2 more sources
On the ultimate tensile strength of tantalum [PDF]
Acta Materialia, 2017 Abstract Strain rate, temperature, and microstructure play a significant role in the mechanical response of materials. Using non-equilibrium molecular dynamics simulations, we characterize the ductile tensile failure of a model body-centered cubic metal, tantalum, over six orders of magnitude in strain rate.
Eric N. Hahn +4 more
openaire +1 more source
Tensile strength of the pipe material determination according to the ultimate tensile strength
IOP Conference Series: Materials Science and Engineering, 2020 Abstract A new calculation method for the strength of concrete pipes, developed, helps to determine the stresses in the walls of concrete pipes under the combined action of an external (compressing pipe) load and internal pressure from the fluid transported under pressure.
B Younis +3 more
openaire +1 more source
Localization and ultimate tensile strength of fiber-reinforced ceramic-matrix composites [PDF]
Mechanics Research Communications, 1994 International ...
Hild, François, Burr, Alain
openaire +3 more sources
Advanced Engineering Materials, EarlyView.This study explores the lightweight potential of laser additive‐manufactured NiTi triply periodic minimal surface sheet lattices. It systematically investigates the effects of relative density and unit cell size on surface quality, deformation recovery, compression behavior, and energy absorption.
Haoming Mo +3 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.It is shown that laser ablation pretreatment under oxygen‐free conditions enables copper–aluminium bonding at significantly lower deformation degrees and improved properties compared to mechanical brushing. Laser ablation further increases interface contact area and induces favourable residual stress states and microstructural compatibility ...
Khemais Barienti +11 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.Low‐cycle fatigue damage in Mn–Mo–Ni reactor pressure vessel steel is examined using a combined electron backscatter diffraction and positron annihilation lifetime spectroscopy approach. The study correlates texture evolution, dislocation substructure development, and vacancy‐type defect formation across uniform, necked, and fracture regions, providing
Apu Sarkar +2 more
wiley +1 more source