Results 101 to 110 of about 97,854 (212)

Ti3C2Tx MXene/Silver Composite Foams For Lightweight, High‐Performance Electromagnetic Interference Shielding and Joule Heating

open access: yesAdvanced Materials Interfaces, EarlyView.
Ultrathin MXene/EMF composite foams achieve a specific shielding efficiency of 749.6 dB.dB·cm3$\mathrm{dB}\cdot {\mathrm{cm}}^{3}$/g, while the silver‐enhanced MXene/Ag/EMF reaches 81.4 dB shielding effectiveness at just 1.0 mm thickness. Both composites exhibit rapid Joule heating, retain stability up to 250∘C$^\circ{\rm C}$, and withstand 1000 ...
Abdullah A. Mahmood   +7 more
wiley   +1 more source

Defect‐Driven Charge Separation in Ba‐Doped SrTiO3: Correlating Photoelectrochemical Performance With Dye‐Selective Photocatalysis

open access: yesAdvanced Materials Interfaces, EarlyView.
Ba‐doped SrTiO3 perovskites establish a direct correlation between photoelectrochemical activity and photocatalytic performance. Optimized Ba0.5Sr0.5TiO3 exhibits enhanced charge separation, photocurrent generation, and visible‐light‐driven dye degradation through defect‐induced oxygen vacancies and lattice distortion.
Sagar A. Nikam   +6 more
wiley   +1 more source

Material Before Morphology: Substrate‐Dependent Mechanical Tuning of Radular Teeth

open access: yesAdvanced Materials Interfaces, EarlyView.
Substrate‐dependent material tuning in Clausilia radular teeth. Closely related taxa retain a conserved gross tooth morphology, but differ in elemental composition and mechanical properties according to feeding substrate. Rock‐associated taxa show increased Ca–Si enrichment and higher stiffness and hardness, especially in the central radular region ...
Ida Lilienthal   +3 more
wiley   +1 more source

High Quality MoS2 Layered Thin Films Obtained by Ionized Jet Deposition Investigated by X‐ray Absorption Spectroscopy at S L2,3 and Mo M2,3 Edges

open access: yesAdvanced Materials Interfaces, EarlyView.
Soft x‐ray absorption spectroscopy at the S L2,3 and Mo M2,3 edges reveals synthesis‐dependent electronic and structural order in MoS2. Bulk, exfoliated, and CVD samples show well‐resolved 2D features, while as‐deposited IJD films appear amorphous but crystallize into ordered 2H‐MoS2 upon moderate annealing, confirming IJD as a viable low‐temperature ...
Giulia Giovanelli   +12 more
wiley   +1 more source

Fabrication of TiN/TiO2 Nanotube‐Based Heterostructure for Hydrogen Sensing Applications

open access: yesAdvanced Materials Interfaces, EarlyView.
A hydrogen sensor based on titanium dioxide nanotubes coated with titanium nitride has been developed. The coating process causes a mixed titanium oxynitride layer to form, which improves the sensor performance. Sensor response R depends on the TiN thickness and is not degraded after 7 days in air.
Esme Isik   +4 more
wiley   +1 more source

Home - About - Disclaimer - Privacy