Results 61 to 70 of about 1,628,958 (286)

Methodology for Determining the Correct Ultrasonic Pulse Velocity in Concrete

Buildings
Quite often, concrete strength parameters must be determined in the shortest possible time. Due to the strong correlation between concrete’s mechanical and acoustic properties, ultrasonic devices can be used for this purpose. However, the ultrasonic pulse velocity (UPV) is influenced by a variety of factors, including the curing and exploitation ...
Uldis Lencis, Aigars Udris, Patricia Kara De Maeijer, Aleksandrs Korjakins   +3 more
openaire   +3 more sources

Investigation of Concrete Segregation by Ultrasonic Pulse Velocity

Journal of Architectural Engineering Technology, 2017
Segregation is the separation of the components of fresh concrete or mortar, which can be caused by bad proportioning, insufficient mixing or excessive vibration. There are several tests which can be measured on hardened concrete or at the beginning of hardening. These are generally based on the percentage of the Fine aggregates between the top and the
Grini Abdelouaheb, Benouis Abdelhalim
openaire   +1 more source

Sacrificial‐Layer‐Assisted Heat‐Affected‐Zone Suppression in Laser Patterning of PET for High‐Performance Flexible Devices

Advanced Functional Materials, EarlyView.
A removable sacrificial polymer layer engineers the thermal boundary condition during nanosecond laser ablation of PET, suppressing heat‐affected‐zone formation without relying on costly ultrafast lasers. This strategy enables deep, high‐aspect‐ratio trenches with no detectable heat‐affected zone, templating silver‐filled mesh electrodes with record ...
Mehdi Zarei, Mirza Sahaluddin, Mostafa Bedewy, Paul W. Leu   +3 more
wiley   +1 more source

Evaluation of Compressive Strength by Non- Destructive Test Using Ultrasonic Pulse Velocity With Maximum Size Aggregate (10 And 20)mm

Journal of Engineering and Sustainable Development, 2014
The concrete is tested non destructively to determine its mechanical properties (compressive strength) which is considered as the main property and the parameter used in its evaluation.
Laith A. Al-jaberi, Asmaa Mahdi Ali
doaj  

Analysis of the Stress-Strain State of operated reinforced Concrete Structures Using Ultrasound

Вестник Дагестанского государственного технического университета: Технические науки
Objective. Research and analysis of parameters of the stress-strain state of reinforced concrete beams using periodic ultrasonic testing in compressed and tensile zones and development of proposals for the application of the method in the inspection and ...
G. V. Nesvetaev, A. V. Kolleganov, N. A. Kolleganov, A. N. Ivlev, A. M. Omarov   +4 more
doaj   +1 more source

Investigation of relationships between ultrasonic pulse velocity and thermal conductivity coefficient in foam concretes [PDF]

, 2016
In this study, using type CEM I 42.5 R Portland cement, limestone powder, polypropylene fibers and super plasticizer, additive foam concrete specimens were produced.
Davraz, M., Koru, M., Kilinçarslan, Ş., Tuzlak, F., Davraz, Metin, KILINÇARSLAN, Şemsettin, Koru, Murat   +6 more
core   +1 more source

Beyond Thin Film Limits—Superhard and Hydrogen‐Free Amorphous Carbon Coatings With Over 100 µm Thickness

Advanced Functional Materials, EarlyView.
For the first time, an extreme‐thick laser‐arc PVD ta‐C (DLC) coating exceeding 100 µm is demonstrated, opening up new possibilities for ultra‐high load bearing capacity. This superhard amorphous carbon architecture combines >50% sp3 bonding, robust adhesion and self‐supporting performance, shielding substrates from plastic flow under extreme contact ...
Martin Zawischa, Frank Kaulfuß, Stefan Makowski, Volker Weihnacht   +3 more
wiley   +1 more source

Influence of Ultrasonic Treatment on the Sedimentation Performance of Slime

Kuangchan zonghe liyong
This is an article in the field of mining engineering. Kaolinite and montmorillonite are the main clay minerals in coal slime, and clay minerals are the main factors affecting the sedimentation of coal slime.
Xiaobin ZHANG, Xin WEN, Weiwei CAO, Zhongshan LI, Jing TAN   +4 more
doaj   +1 more source

The assessment of concrete quality by ultrasonic pulse velocity

Journal of Science and Technology in Civil Engineering (STCE) - NUCE, 2018
In the present study, the uniformity and potential internal defects of concrete elements in situ were assessed by using Ultrasonic Pulse Velocity (UPV) testing method according to TCVN 9357:2012. Thirteen cross beams with dimension of 4.8 x 1.5 x 1.5 m3 were selected to measure the pulse velocity. Three cross beams were used to check potential internal
openaire   +2 more sources

Bioinspired Adaptive Sensors: A Review on Current Developments in Theory and Application

Advanced Materials, EarlyView.
This review comprehensively summarizes the recent progress in the design and fabrication of sensory‐adaptation‐inspired devices and highlights their valuable applications in electronic skin, wearable electronics, and machine vision. The existing challenges and future directions are addressed in aspects such as device performance optimization ...
Guodong Gong, You Zhou, Qingxiu Li, Wenyu Zhao, Sunyingyue Geng, Hangfei Li, Yan‐Bing Leng, Shirui Zhu, Guanglong Ding, Yongbiao Zhai, Ziyu Lv, Ye Zhou, Su‐Ting Han   +12 more
wiley   +1 more source