Results 41 to 50 of about 1,131 (107)
Analysis of the Stress-Strain State of operated reinforced Concrete Structures Using Ultrasound
Вестник Дагестанского государственного технического университета: Технические наукиObjective. Research and analysis of parameters of the stress-strain state of reinforced concrete beams using periodic ultrasonic testing in compressed and tensile zones and development of proposals for the application of the method in the inspection and ...
G. V. Nesvetaev +4 more
doaj +1 more source
The assessment of concrete quality by ultrasonic pulse velocity
Journal of Science and Technology in Civil Engineering (STCE) - NUCE, 2018 In the present study, the uniformity and potential internal defects of concrete elements in situ were assessed by using Ultrasonic Pulse Velocity (UPV) testing method according to TCVN 9357:2012. Thirteen cross beams with dimension of 4.8 x 1.5 x 1.5 m3 were selected to measure the pulse velocity. Three cross beams were used to check potential internal
openaire +2 more sources
Influence of Ultrasonic Treatment on the Sedimentation Performance of Slime
Kuangchan zonghe liyongThis is an article in the field of mining engineering. Kaolinite and montmorillonite are the main clay minerals in coal slime, and clay minerals are the main factors affecting the sedimentation of coal slime.
Xiaobin ZHANG +4 more
doaj +1 more source
Crystals, 2020 The purpose of this paper is to establish some correlations between the main technical parameter with regard to the cement-based materials technology, the 28-day compressive strength, and ultrasonic pulse velocity of standard mortar samples cured at ...
Esteban Estévez +3 more
doaj +1 more source
دراسة بعض خواص الخرسانة الرغویة باعتماد سرعة الموجات فوق الصوتیة
Iraqi Journal of Civil Engineering, 2007 Concrete is by far the most widely used construction material now today. Foamed concrete is light building material with good strength as well as low thermal conductivity and easy workability; it is produced by either Mix Foam Method or Preformed Foam ...
Amir Abdul-Rahman Hilal Al-Dulaimi
doaj +1 more source
Rekayasa Sipil, 2019 This research aims to know the relationship of the pulse velocity to compression strength with a variation of the quality of the concrete based on the ultrasonic pulse velocity.
Kushariyanto +2 more
doaj +1 more source
Effect of Pouring Time on the Integrity of Pulverized Fuel Ash Concrete
Applied SciencesThe effects of pouring time intervals on the integrity of pulverized fuel ash (PFA) concrete were evaluated by measuring ultrasonic pulse velocity and compressive strength.
Longyue Ni +3 more
doaj +1 more source
THE EFFECT OF VARIATION CONCRETE CUBE OF AXIAL LOAD ON ULTRASONIC PULSE VELOCITY TRANSMITTER
Journal of the Civil Engineering Forum, 2015 Nowadays, Non Destructive Tests have been applied in some quality evaluation of existing concretes on site. One of the Non Destructive Test (NDT) methods is the application of the Ultrasonic Pulse Velocity (UPV) method. In general, utilizations of UPV as
Faqih Ma’arif +2 more
doaj +1 more source
Ultrasonic Pulse Velocity Evaluation of Cementitious Materials
, 2011 T. H. Panzera1, A. L. Christoforo1, F. P. Cota1, P. H. R. Borges2 and C. R. Bowen3 1Department of Mechanical Engineering, Federal University of Sao Joao del Rei UFSJ, Praca Frei Orlando, 170 Sao Joao Del Rei – MG, 2Department of Civil Engineering, Federal Centre for Technological Education of Minas Gerais, CEFET-MG, 3Materials Research Centre ...
Tulio H. Panzera +4 more
openaire +2 more sources
Rekayasa Sipil, 2019 Field testing is divided into 2 tests i.e. by destroying test structures or destructive tests and without destroying the structure or called a non-destructive test (NDT) One of them using the ultrasonic pulse rate (UPV).
Alif Iqbal Nur Hidayat +2 more
doaj +1 more source