Results 41 to 50 of about 45,052 (312)
Advanced Engineering Materials, Volume 27, Issue 6, March 2025.ErB4 and NdB4 nanostructured powders are produced by mechanochemical synthesis. 5 h mechanical alloying and 4 M HCl acid leaching are used in the production. ErB4 and NdB4 powders exhibit maximum magnetization of 0.4726 emu g−1 accompanied with an antiferromagnetic‐to‐paramagnetic phase transition at about TN = 18 K and 0.132 emu g−1 with a maximum at ...
Burçak Boztemur +5 more
wiley +1 more source
Signal processing methods for defect detection in multi-wire helical waveguides using ultrasonic guided waves [PDF]
, 2015 This thesis was submitted for the degree of Master of Philosophy and awarded by Brunel University LondonNon-Destructive Testing of industrial components carries vital importance, both financially and safety-wise.
Yucel, Mehmet Kerim
core
Monitoring the lubricant condition in a low-speed rolling element bearing using high frequency stress waves [PDF]
, 2002 This paper presents the results of an investigation into the development of a reliable, nonintrusive and effective technique capable of accessing the lubrication condition within a low-speed rotating bearing.
Mba, David +8 more
core +1 more source
, 2020 The propagation of ultrasonic guided waves in solids is an important area of scientific inquiry, primarily due to their practical applications for nondestructive characterization of materials, such as nondestructive inspection, quality assurance testing, structural health monitoring, and providing a material state awareness.
openaire +2 more sources
Revista IBRACON de Estruturas e Materiais, 2018 In the research program both longitudinal and transverse ultrasonic waves were applied to concrete specimens under uniaxial compression and tensile diametrical compression.
A. V. P. ARAUJO +3 more
doaj +2 more sources
A Compact Spin‐Coated Graphene UWB Antenna for Breast Tumor Detection
Advanced Engineering Materials, EarlyView.A compact, spin‐coated graphene ultra‐wideband patch antenna designed for breast tumor detection, capable of distinguishing between malignant and benign tumors. This innovative antenna can serve as an effective initial screening tool, particularly in resource‐limited settings such as rural areas, where access to advanced medical equipment like MRI and ...
Raja Rashidul Hasan +9 more
wiley +1 more source
Numerical Simulation of Nonlinear Lamb Waves Used in a Thin Plate for Detecting Buried Micro-Cracks
Sensors, 2014 Compared with conventional linear ultrasonic inspection methods, which are sensitive only to severe defects, nonlinear ultrasonic inspection methods are better for revealing micro-cracks in thin plates.
Xiang Wan +3 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.Scandium (Sc)‐doped AlCoCrFeMo HEA coatings are fabricated via flame spraying with 0.1, 0.3, and 0.5 wt% Sc additions. Among these, the HEA‐Sc0.3 coating exhibits the highest corrosion resistance, indicated by a more positive corrosion potential and lower current density.
Pankaj Kumar +7 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.Sol–gel‐derived ZnO–rGO hybrid nanoparticles enable Al7075 powder‐metallurgy composites to achieve concurrent gains in hardness and thermal conductivity while markedly lowering friction and wear. The hybrid architecture couples ZnO‐based load support with rGO‐assisted lamellar sliding and heat spreading, revealing a promising route toward lightweight ...
Bunyamin Aksakal +3 more
wiley +1 more source
Ultrasound assisted particle and cell manipulation on-chip [PDF]
, 2013 Ultrasonic fields are able to exert forces on cells and other micron-scale particles, including microbubbles. The technology is compatible with existing lab-on-chip techniques and is complementary to many alternative manipulation approaches due to its ...
Cochran, Sandy +2 more
core +1 more source