Results 101 to 110 of about 2,293,035 (150)
Anechoic coatings are of significance for enhancing the acoustic stealth of underwater equipment. Acoustic coatings with multi-layers of periodic solid inclusions are proposed and investigated for broadband sound absorption. Firstly, an analysis model is
Xiaogang Li +4 more
doaj +1 more source
On the reliability of the Autosub autonomous underwater vehicle [PDF]
As autonomous underwater vehicles (AUVs) enter operational service an assessment of their reliability is timely. Using the Autosub AUV as an example, several design issues affecting reliability are discussed, followed by an analysis of recorded faults ...
Stevenson, P. +8 more
core
Low-frequency underwater noise absorption remains challenging because the large characteristic acoustic impedance and long wavelength in water make conventional porous/fibrous treatments impractical, while thermoviscous-loss-based resonant absorbers often suffer from weak intrinsic dissipation and narrowband performance.
Wang, Jiayu +6 more
openaire +2 more sources
Anechoic coatings are usually applied to underwater targets, such as submarine shells, to reduce the detection distance of enemy active sonar. The main challenge is obtaining low-frequency and broadband sound absorption characteristics through the design
Yiping Sun +4 more
doaj +1 more source
This study proposes a hybrid acoustic metamaterial (HAM) composed of four quasi-Helmholtz resonators (QHRs, with rubber liners and embedded necks) and one boundary-constrained viscoelastic material (BVM) arranged in parallel.
Ming Li, Fengxian Xin
doaj +1 more source
The primary structural configuration of underwater equipment consists of cylindrical shells. To study the characteristics of the acoustic target strength(TS) of a cylindrical shell partially covered with anechoic coatings, an anechoic coating with an ...
Qi MA, Shifeng NI, Hao GENG, Haibin YANG
doaj +1 more source
The laconic calculating formulae of arbitrary multiple-layer model’s acoustic characteristics are introduced with sound transmission theoretics in multilayer mediums.
Wen Cheng Zhang +2 more
core +1 more source
By embedding center-supported graded-circular-plates (CS-GCPs) into an elastomer, a deep-subwavelength and hydrostatic-pressure-resistant meta-absorber was designed and manufactured for sound absorption (SA) under hydrostatic pressure.
Yanni Zhang +4 more
doaj +1 more source
Acoustic stealth of underwater vehicles demands sound insulation and decoupling materials (SIDM) with good acoustic performance, high strength, and relatively low acoustic impedance. To address this, low elastic modulus AlPO4 was selected as the backbone
Bingqing Zhao +6 more
doaj +1 more source
CHARACTERIZATION OF NATURAL FIBERS FOR SOUND ABSORPTION
Green materials, either natural or from recycled materials, are becoming a valid alternative to traditional synthetic materials for sound absorption treatments.
Berardi, Umberto, IANNACE, Gino
core

