Results 51 to 60 of about 66,747 (201)
Applied Sciences, 2018 This paper presents the results of an experimental study on the effect of limestone powder on the compressive strength, tensile behavior, and micromechanical parameters of a highly ductile cement composite incorporating limestone powder.
Jung Hwan Hyun +2 more
doaj +1 more source
Mechanical Properties of Microstructural Components of Inorganic Materials [PDF]
, 2013 Disertační práce se zabývá studiem strukturních a mechanických vlastností anorganických materiálů. Cílem je nalezení jednotlivých fází ve zkoumaném materiálu a hlavně lokalizace (mechanicky) nejslabšího místa, jeho ovlivnění a následně výroba materiálu o
Wasserbauer, Jaromír
core
, 2014 We present numerical investigations based on the Luttinger-Kohn four-band $k \cdot p$ theory and, accordingly, establish a quantitatively valid model of the excitonic fine structures of droplet epitaxial GaAs/AlGaAs quantum dots under uni-axial stress ...
Cheng, Shun-Jen +2 more
core +1 more source
The effect of material cyclic deformation properties on residual stress generation by laser shock processing [PDF]
, 2019 Laser shock processing (LSP) is a mechanical surface treatment to induce a compressive residual stress state into the near surface region of a metallic component.
Angulo, I. +6 more
core +1 more source
MedžiagotyraThis study improves the mechanical properties of recycled concrete by adding basalt fibers, thereby promoting the widespread application of recycled concrete in engineering.
Shu SUN +3 more
doaj +1 more source
Water saturation induced changer in the indirect (Brazilian) tensile strength and the failure mode of some igneous rock materials [PDF]
, 2020 The present study concentrates on water induced strength reduction and variation of the failure mode in indirect (Brazilian) tension tests of several igneous rock materials under three moisture cases of oven-dry, air-dry and fully saturated states.
Komurlu, Eren, Yasar, Serdar
core
Plasticity size effects in tension and compression of single crystals [PDF]
, 2005 The effect of size and loading conditions on the tension and compression stress–strain response of micron-sized planar crystals is investigated using discrete dislocation plasticity.
Deshpande, V.S., +2 more
core +3 more sources
Microstructure Controlled Shear Band Pattern Formation and Enhanced Plasticity of Bulk Metallic Glasses Containing in situ Formed Ductile Phase Dendrite Dispersions [PDF]
, 2000 Results are presented for a ductile metal reinforced bulk metallic glass matrix composite based on glass forming compositions in the Zr-Ti-Cu-Ni-Be system.
Hays, C. C., Johnson, W. L., Kim, C. P.
core +1 more source
Uniaxial and Plane-Strain Compressive Strength of Model Ice [PDF]
Annals of Glaciology, 1983 In order to interpret reliably the results of model tests which involve compressive (crushing) failures, the compressive strength of the model ice must be known. In this paper, the uniaxial and plane-strain compressive strengths of carbamide (urea) model ice are documented for scale factors of 40>λ>5.
openaire +3 more sources
Predicting uniaxial compressive strength using Support Vector Machine algorithm [PDF]
Warta Geologi, 2019 Compressive strength is the most important parameter in rock since all loads will be transferred and rest on the rock which is based on the load bearing capacity of rock in compression. However, obtaining the compressive strength or mostly measured, the uniaxial compressive strength (UCS) from the laboratory test requires certain standard and also cost
Hafedz Zakaria +3 more
openaire +1 more source