Results 61 to 70 of about 37,380 (257)

3D‐Printed Titanium Gyroid Scaffold Structure Integrated With Tough Hybrid Materials for Cartilage Replacement

open access: yesAdvanced Engineering Materials, EarlyView.
This study proposes a potential device design for joint cartilage replacement. Silica‐polytetrahydrofuran (SiO2‐PolyTHF) hybrids with customizable mechanical properties were developed to mimic the characteristics of a natural meniscus. These were synthesized through a two‐pot sol–gel hybrid process.
Yu‐Chien Lin   +12 more
wiley   +1 more source

Influence of Application Time and Etching Mode of Universal Adhesives on Enamel Adhesion.

open access: yesThe journal of adhesive dentistry, 2019
To investigate the influence of application time and etching mode of universal adhesives on enamel adhesion.Five universal adhesives, Adhese Universal, Bondmer Lightless, Clearfil Universal Bond Quick, G-Premio Bond, and Scotchbond Universal, were used. Bovine incisors were prepared and divided into four groups of ten teeth each.
Keiichi, Sai   +7 more
openaire   +2 more sources

Elastic–Plastic Modeling and Experimental Characterization of Granular Jamming Actuators

open access: yesAdvanced Engineering Materials, EarlyView.
Granular jamming enables rapid switching between soft and rigid mechanical states. Here, a reduced‐order elastic‐perfectly‐plastic beam framework captures pressure‐dependent loading, unloading, residual deformation, and hysteresis in jammed beams, while matching three‐point bending experiments across materials and geometries. The framework links design
Saheli Patel   +2 more
wiley   +1 more source

EVALUATION OF SHEAR BOND STRENGTH AND FRACTOGRAPHIC ANALYSIS OF DIFFERENT SELF-ETCH ADHESIVE SYSTEMS (IN VITRO STUDY) [PDF]

open access: yesAlexandria Dental Journal
Objective : The purpose of this Invitro study is to measure the shear bond strength of new aqua bond contaminated in artificial saliva in comparison with two other universal adhesive composite bonding agents (tetric N bond universal, all bond universal ...
Mohamed El Farash   +3 more
doaj   +1 more source

Thermal Cycle–Microstructure–Property Relationships in Rail Steel Heat‐Affected Zone Simulated by Gleeble

open access: yesAdvanced Engineering Materials, EarlyView.
Microstructural evolution of premium rail steel during flash butt welding (FBW), comparing physically simulated heat‐affected zones with actual weld regions. Thermal cycles induce phase transformations and microstructural heterogeneity that influence weld quality and mechanical performance. These findings provide insights into optimizing FBW parameters
Emmanoelle Cintra da Cunha Araújo   +15 more
wiley   +1 more source

Microtensile bond strength and dentin–adhesive interface of universal adhesives before and after artificial aging: an in vitro study

open access: yesScientific Reports
Universal adhesives (UAs) are widely used for resin composite restorations; however, the durability of the dentin–adhesive interface after aging remains a key clinical concern, as interfacial degradation may compromise bond stability over time. Therefore,
Flor Santander-Rengifo   +2 more
doaj   +1 more source

Silane-Containing Self-Adhesive Resin Cement vs. Conventional Strategies in Fiber Post Application: A Push-Out Bond Strength and Failure Mode Study

open access: yesApplied Sciences
This study evaluated the push-out bond strength (PBS) and failure modes of fiber posts cemented with silane-containing self-adhesive resin cement (SARC) compared with conventional SARC and universal adhesive strategies, considering the effects of root ...
Zeynep Hale Keles   +3 more
doaj   +1 more source

Laser‐Induced Graphene from Waste Almond Shells

open access: yesAdvanced Functional Materials, EarlyView.
Almond shells, an abundant agricultural by‐product, are repurposed to create a fully bioderived almond shell/chitosan composite (ASC) degradable in soil. ASC is converted into laser‐induced graphene (LIG) by laser scribing and proposed as a substrate for transient electronics.
Yulia Steksova   +9 more
wiley   +1 more source

Does Rubbing of Universal Adhesive Reduce the 
Negative Effect of Saliva on Adhesion?

open access: yesThe journal of adhesive dentistry, 2021
To evaluate in vitro the effect of saliva contamination on bond strength of a universal adhesive applied with actively (with rubbing motion) and passively (without rubbing motion).A total of 144 bovine dentin samples were used, and the universal adhesive, Clearfil Universal Bond Quick, was either applied in accordance with the manufacturer's ...
ATALAY, CANSU, MERAL, ECE
openaire   +2 more sources

From Food to Power: Hydrogel Thermoelectrics for Ingestible Electronics

open access: yesAdvanced Functional Materials, EarlyView.
We introduce a fully edible thermoelectric–electrochromic platform that harvests heat from food and converts it into a visible color change. N‐type and p‐type hydrogel thermoelectric generators connected in series power anthocyanin‐based electrochromic displays, demonstrating the feasibility of safe, biodegradable, ingestible systems for on‐food ...
Antonia Georgopoulou   +3 more
wiley   +1 more source

Home - About - Disclaimer - Privacy