Results 171 to 180 of about 275,314 (235)

Thermophilic anaerobic treatment and biogas generation from wastewater produced in an advanced biorefinery process

open access: yesBiofuels, Bioproducts and Biorefining, Volume 20, Issue 6, Page 2272-2283, November/December 2026.
Abstract Anaerobic digestion can be an alternative method for treating wastewater from second‐generation biorefineries while simultaneously producing biogas. However, the feasibility of the process and key operational parameters by which wastewater produced in lignocellulosic biorefineries affects reactor performance remain poorly understood.
Jairo M. Carrillo‐Osorio   +1 more
wiley   +1 more source

Long‐term assessment of the effect of OLR, HRT and temperature on domestic sewage treatment using AnMBR to enhance biomethane production

open access: yesBiofuels, Bioproducts and Biorefining, Volume 20, Issue 6, Page 2368-2378, November/December 2026.
Abstract The objective of this study was to evaluate the potential of an anaerobic membrane bioreactor (AnMBR) to treat domestic sewage by removing organic matter and nutrients while producing biogas. AnMBRs combine anaerobic digestion with membrane filtration, and stand out for their low energy consumption, low sludge production and potential for ...
Rennio Felix de Sena   +5 more
wiley   +1 more source

Why Should Spinel Formation be Controlled in Promoted Ni–Mg–Al Mixed Oxide Catalyst for Ambient Pressure CO2 Hydrogenation?

open access: yesChemCatChem, Volume 18, Issue 21, 12 November 2026.
Thermal solution combustion synthesis (SCS) produced Ni–Mg–Al catalysts with superior textural properties, basicity, and reducibility compared to microwave SCS. Among microwave‐derived catalysts, yttrium suppressed excessive spinel formation, enhanced Ni reducibility, and promoted metallic Ni characteristics, overcoming synthesis‐related limitations ...
Paulina Summa   +2 more
wiley   +1 more source

Revisiting the synthesis of dimethyl carbonate from methanol and carbon dioxide

open access: yesThe Canadian Journal of Chemical Engineering, Volume 104, Issue 11, Page 5954-5978, November 2026.
Abstract The process for producing dimethyl carbonate (DMC) from carbon dioxide (CO2) and methanol is explored in this article. It provides an overview of the thermodynamics involved in DMC synthesis, discussing the challenges and potential solutions. The article highlights the reported use of catalysts and dehydrating agents to improve DMC yield and ...
Diego Alexander Santos Araque   +3 more
wiley   +1 more source

MXene Electrocatalysts for Selective Nitrogen Reduction Reaction‐to‐Ammonia Production: Surface Chemistry, Electronic Framework, and Design Principles

open access: yesCarbon Neutralization, Volume 5, Issue 6, November 2026.
Advanced MXene electrocatalysts with engineered active sites and tailored electronic structures facilitate selective electrochemical nitrogen reduction to ammonia under ambient conditions. Optimized conductivity, surface chemistry, and multimetallic compositions improve catalytic efficiency while minimizing hydrogen evolution, offering a promising ...
Syed Asim Ali   +3 more
wiley   +1 more source

CRM197 preserves native diphtheria toxin epitopes better than formaldehyde toxoid: structural and serologic implications for vaccines and serodiagnostics

open access: yesClinical &Translational Immunology, Volume 15, Issue 11, 2026.
Formaldehyde detoxification of diphtheria toxin is assumed to preserve the epitopes that vaccines and diagnostic assays rely on. Comparing immune sera against native toxin, CRM197, and formaldehyde‐detoxified toxoid, we found that reactivity to CRM197 tracks reactivity to native toxin more closely than toxoid does in mice, with the same direction of ...
Denys Kolybo   +10 more
wiley   +1 more source

Highly Permeable CeO2 Porous Hollow Microspheres with Multilevel Gas Channels for Rapid NH3 Gas Response and Recovery Performance

open access: yesENERGY &ENVIRONMENTAL MATERIALS, Volume 9, Issue 6, November 2026.
In this study, a series of highly permeable CeO2 porous hollow microspheres with multilevel gas channels and tunable pore sizes were first prepared via the hydrothermal method, achieving rapid response and fast recovery to ammonia gas. Fast response and recovery performance is highly significant for real‐time monitoring of NH3 gas due to the toxic and ...
Mengke Li   +11 more
wiley   +1 more source

Recent Advances in Pickering Emulsion Templated Phase Change Material Microcapsules: Design, Fabrication, and Multifunctional Applications

open access: yesENERGY &ENVIRONMENTAL MATERIALS, Volume 9, Issue 6, November 2026.
Fabrication process of phase change microcapsules using a Pickering emulsion template method and their subsequent applications. The increasing demand for efficient thermal energy storage systems has driven the development of phase change material microcapsules (PCMMs), which provide high energy‐storage density, reversible phase change, and reduced ...
Ziyan Li   +4 more
wiley   +1 more source

Comparison of the Properties of Urea-Formaldehyde Resins by the Use of Formalin or Urea Formaldehyde Condensates

Journal of Adhesion Science and Technology, 2018
In industry, formalin and urea formaldehyde condensates (UFC) are used for the preparation of urea-formaldehyde adhesives. The aim of this study was to evaluate the characteristics of a UF resin prepared with formalin (42% concentration) and two kinds of UFC with various urea content (F/U ∼ 5 and 4.3 malar ratio).
Manouchehr Mamaghani   +2 more
exaly   +2 more sources

Home - About - Disclaimer - Privacy