Results 11 to 20 of about 46,783 (309)

Evaluation of enhanced bioremediation for soils contaminated with used lubricating oil in soil slurry system [PDF]

open access: yesSongklanakarin Journal of Science and Technology (SJST), 2020
This study was conducted to evaluate the biodegradability of used lubricating oil (ULO) in soil slurry system using bioaugmentation and biostimultion approaches. Bioaugmentation with SC9 consortium isolated from ULO-contaminated soil and biostimulation
Naruemon Meeboon, Suppasil Maneerat
doaj   +1 more source

Handling of used lubricating oil in Tabasco, Mexico

open access: yesDyna, 2022
The improper handling of used lubricating oil (ULO) in Tabasco, Mexico, and worldwide is a serious problem posing a high risk of soil and water pollution.
José Abisenas Alvarez-Rivera   +6 more
doaj   +1 more source

Reclamation of used lubricating oils [PDF]

open access: yesCurrent World Environment, 2010
Lubricating oils are widely used to reduce friction and wear by interposing a film of material between rubbing surfaces. However, the used lubricant oil does not evaporate and less subject to biodegradation. It requires proper treatment before it can be discharged to the environment. Recently, there is an increase tendency of using used lubricating oil
Vineet Katiyar, Sattar Husain
openaire   +1 more source

Preparation of Emulsified Fuel from used lubricating oil [PDF]

open access: yesEngineering and Technology Journal, 2017
The use of diesel fuel in diesel engines when they run produces large amounts of environmental emitiondue to the high flame tem temperature when combustion also high quantities of used lubricating oilsproduce annually, and the disposal process has caused
D. Muna M. Khudhair   +5 more
doaj   +1 more source

Self-Anti-Disturbance Control of a Hydraulic System Subjected to Variable Static Loads

open access: yesApplied Sciences, 2022
A hydraulic system’s lubricating oil is subject to serialized variable static loads with performance. An improved self-turbulent flow algorithm, based on the real-time acquisition and monitoring of lubricating oil static pressure in a hydraulic system to
Xigui Wang   +3 more
doaj   +1 more source

The Initial Boiling Point of Lubricating Oil as an Indicator for the Assessment of the Possible Contamination of Lubricating Oil with Diesel Oil

open access: yesEnergies, 2022
This article provides a brief introduction to the indicators of the volatility and flammability of lubricating oils and fuels. It is proposed that the initial boiling point be used as an indicator of the contamination of lubricating oil with distillate ...
Leszek Chybowski
doaj   +1 more source

Biodegradation of Used Synthetic Lubricating Oil by Brevundimonas diminuta AKL 1.6

open access: yesMakara Journal of Science, 2017
Illegal disposal of used lubricating oil is a serious hazard to the environment and public health. This study is aimed at examining the biodegradation process of used synthetic lubricant using local microorganism.
Witono Basuki
doaj   +1 more source

Recycling of waste engine oils using a new washing agent [PDF]

open access: yes, 2013
This paper addresses recycling of waste engine oils treated using acetic acid. A recycling process was developed which eventually led to comparable results with some of the conventional methods.
Hamawand, Ihsan   +2 more
core   +5 more sources

Characterization of Lubricating Oil Using Ultrasound

open access: yesJournal of the Brazilian Society of Mechanical Sciences, 2001
This paper presents an ultrasonic method to measure small concentrations of water in lubricating oil. It uses an ultrasonic measurement cell composed by a piezoceramic emitter (5 and 10 MHz), and a large aperture PVDF receiver that eliminates diffraction effects.
Higuti, Ricardo Tokio   +2 more
openaire   +3 more sources

Demand Analysis of Lubricating Oil in Spur Gear Pairs

open access: yesApplied Sciences, 2020
Theoretical calculation and numerical simulation are used to investigate the lubricating oil demand of spur gears. In accordance with the function of lubricating oil during the meshing process, oil demand is regarded as the superposition of oil for ...
Fuchun Jia   +4 more
doaj   +1 more source

Home - About - Disclaimer - Privacy