Results 71 to 80 of about 41,901 (252)
This article aims to highlight the importance of including quantitative measurements when conducting flow visualization tests, such as those performed in towing tanks, within fluid mechanics analysis. It investigates the possibility of measuring velocity
José Juan Aliaga-Maraver +7 more
doaj +1 more source
Acoustic‐driven surface cleaning with millimeter‐sized bubbles at translational resonance
Time‐lapse visualization comparing bubble trajectories. The top panel (0 Hz) shows a bubble's linear path under no acoustic forcing, while the bottom panel (50 Hz) demonstrates the oscillatory motion induced by acoustic waves at a resonance mode. This mechanism holds promising potential for applications such as surface cleaning.
Yan Jun Lin +2 more
wiley +1 more source
Investigation on tunnel stability considering pipe‐roof support with transparent soil technology
This study integrates transparent soil technology, 3D reconstruction and numerical simulation to captures the full‐field deformation of shield tunnel instability. Results demonstrate that pipe‐roof support enhances stability via the “soil‐arching barrier effect,” effectively restraining failure wedge development by extending stress transfer paths ...
Zhi Jia +4 more
wiley +1 more source
Stereo Digital Particle Image Velocimetry Investigation of a Free Surface Mixing Layer [PDF]
Shear flows in the vicinity of a free surface are a problem with numerous applications, perhaps the most obvious being the wakes of seagoing surface vessels.
Dooley, Bradley Scott
core +1 more source
Echo Particle Image Velocimetry [PDF]
The transport of mass, momentum, and energy in fluid flows is ultimately determined by spatiotemporal distributions of the fluid velocity field.(1) Consequently, a prerequisite for understanding, predicting, and controlling fluid flows is the capability to measure the velocity field with adequate spatial and temporal resolution.(2) For velocity ...
Nicholas, DeMarchi, Christopher, White
openaire +2 more sources
ABSTRACT Reliable characterization of mineralogical and textural changes in rock samples is essential for understanding fluid–rock interactions, particularly in experimental studies simulating subsurface conditions. This study presents a reproducible protocol for scanning electron microscopy (SEM) analysis of rock surfaces before and after exposure to ...
Berta Ordóñez‐Casado +3 more
wiley +1 more source
Nightshade Velocimetry Needs [PDF]
Author Institution: Los Alamos National LaboratorySlides presented at the 2018 Photonic Doppler Velocimetry (PDV) Users Workshop, Drury Plaza Hotel, Santa Fe, New Mexico, May 16-18 ...
Harding, J. Patrick
core
ABSTRACT Objective To assess the efficacy of middle cerebral artery (MCA) Doppler ultrasonography in predicting neurological and respiratory outcomes in fetuses with fetal growth restriction (FGR) and to establish a correlation between MCA Doppler and head circumference (HC). Method Retrospective cohort study examining singleton pregnancies affected by
Silvia Visentin +6 more
wiley +1 more source
Optimizing PWM performance requires not only appropriate duty cycle selection, but also careful choice of adjuvant formulation tailored to each nozzle type. Drift control agents increased droplet size and reduced fine droplets, mitigating PWM‐induced variability. Decreasing the duty cycle consistently narrowed the spray angle.
João Paulo Arantes Rodrigues da Cunha +3 more
wiley +1 more source
Development and applications of two and three component particle image velocimetry techniques for simultaneous measurement in multi-phase flows and automative fuel sprays [PDF]
The introduction of a new imaging approach for simultaneous multi-phase and multi-constituent velocity measurements is the main focus of this research. The proposed approach is based on the use of a single off-the-shelf colour camera which will enable ...
Jaimes, Diego Alejandro Angarita
core

