Results 31 to 40 of about 7,984 (236)

Strategic Use of CAD-CAM Interim Restoration for the Recovery of the Vertical Dimension of Occlusion in the Posterior Partially Edentulous Jaw

Applied Sciences, 2020
Occlusal contact loss occasionally occurs following the placement of implant-supported fixed dental prostheses in the posterior region. This complication is caused by the change in the vertical dimension of occlusion after the recovery of mastication ...
Hai Yen Mai, Jae-Min Seo, Jae-Kwang Jung, Du-Hyeong Lee   +3 more
doaj   +1 more source

Analysis of coherence between Vertical Dimension of Occlusion (VDO) obtained clinically and through cephalometric analysis. A cross-sectional study [PDF]

Revista de Odontologia da UNESP
Introduction Determining the VDO is one of the most important requirements in restorative dentistry, as it is crucial for good aesthetic and functional harmony. However, due to its empirical nature, a combination of methods is clinically recommended, and
Marcelo Noboru TANIZAKA, Elisa Mattias SARTORI, Farid Jamil Silva de ARRUDA, Eduardo Romagna MACHADO, Ana Cláudia Moreira Melo TOYOFUKU, Ivete Aparecida de Mattias SARTORI   +5 more
doaj   +1 more source

CHANGES IN THE VERTICAL DIMENSION OF OCCLUSION DURING DIFFERENT PERIODS OF COMPLETE DENTURE WEAR - a comparative study. [PDF]

Journal of IMAB, 2014
The exact determination of vertical dimension of occlusion is of great significance for the recreation of the functional, esthetical and prophylactic biological factors for the edentulous patients.
Hrisdana Hadjieva, Mariana Dimova, Elena Hadjieva, Stefan Todorov   +3 more
doaj   +1 more source

Preservation of occlusal vertical dimension in overdentures

The Journal of the American Dental Association, 1978
The preextraction record is used to reestablish the occlusal vertical dimension in immediate and in later overdentures. A colored dot on the denture can be used to verify the occlusal vertical dimension after the dentures have been inserted.
Dr. Levin and Dr. Lepley were affiliated with the Memorial Sloan-Kettering Cancer Center, New York. Dr. Levin is currently affiliated with the department of removable prosthodontics, College of Dentistry, University of Florida, PO Box J435, Gainesville Address requests for reprints to Dr. Levin. ( host institution ), Levin, Alan C. ( author ), Shifman, Arie ( author ), Lepley, James B. ( author )   +3 more
openaire   +3 more sources

Correlation of the vertical dimension of occlusion with five distances between facial landmarks among those of Batak Toba ethnicity

Dental Journal, 2020
Background: The normal vertical dimension of occlusion (VDO) results in orofacial and temporomandibular joint (TMJ) biomechanical balance. If the VDO changes due to attrition, full edentulism, accidents involving the lower third of the face and even ...
Rehulina Ginting, Debora Lovelisa Hinson Simbolon   +1 more
doaj   +1 more source

Preserving esthetics, occlusion and occlusal vertical dimension in a patient with fixed prostheses seeking dental implant treatment

Saudi Dental Journal, 2016
The preservation of esthetics and occlusal vertical dimension is critical in patients with existing full-arch tooth-retained fixed prostheses. This clinical report describes the provision of a maxillary immediate complete denture in a patient with a ...
Abdulaziz Al Baker, Syed Rashid Habib, Mohammad D. Al Amri   +2 more
doaj   +1 more source

An Innovative Technique for Rebasing of Complete Arch Implant Fixed Prosthesis: A Case Report [PDF]

Dental Journal of Advance Studies, 2023
This case report targets to present a technique for the substitution of acrylic resin denture base material and teeth for an implant-retained fixed complete denture utilizing the existing metallic framework.
Greesham Sharma, Tarun Kalra, Manjit Kumar, Ajay Bansal, Shefali Singh Malik   +4 more
doaj   +1 more source

The neutral zone and vertical dimension of occlusion

Medicinski pregled, 2009
Introduction. More recent research points out to the existence of a new concept of the technique for locating the neutral zone. The objective of the study was to determine the effect of changing vertical dimension of occlusion, as well as that of the alveolar ridge type, on the neutral zone dimensions. Material and methods.
Ljiljana, Aleksov, Sasa, Stanković, Zorica, Ajduković   +2 more
openaire   +3 more sources

Assessment of the clinical procedures used for determination of vertical dimension of occlusion and centric relation in edentulous patients [PDF]

Romanian Journal of Stomatology
Background and aim. This study aims to explore the most widely used methods for managing patients who are completely edentulous to determine the intermaxillary relations, also known as the centric relation and vertical dimension of occlusion.
Cecilia Bacali, Anne-Marie Constantin, Ioana Marginean, Oana Almasan   +3 more
doaj   +1 more source

Influence of balanced occlusion in complete dentures on the decrease in reduction of an edentulous ridge [PDF]

Vojnosanitetski Pregled, 2012
Background/Aim. Balanced occlusal arrangement of artificial teeth and balanced occlusion is a specific type of occlusion that preserves the stability of complete dentures.
Poštić Srđan D.
doaj   +1 more source