Results 51 to 60 of about 3,560,321 (246)
Relation between vibrotactile perception thresholds and reductions in finger blood flow induced by vibration of the hand at frequencies in the range 8–250 Hz [PDF]
Purpose: this study investigated how the vasoconstriction induced by vibration depends on the frequency of vibration when the vibration magnitude is defined by individual thresholds for perceiving vibration [i.e.
Ye, Ying, Griffin, Michael J.
core +1 more source
Large-reclined seating has emerged as a favored configuration in the luxury transport sector. While the static advantages are evident, the effect of this posture on dynamic comfort is not clear.
Zefeng Lin +4 more
doaj +1 more source
ErB4 and NdB4 nanostructured powders are produced by mechanochemical synthesis. 5 h mechanical alloying and 4 M HCl acid leaching are used in the production. ErB4 and NdB4 powders exhibit maximum magnetization of 0.4726 emu g−1 accompanied with an antiferromagnetic‐to‐paramagnetic phase transition at about TN = 18 K and 0.132 emu g−1 with a maximum at ...
Burçak Boztemur +5 more
wiley +1 more source
Active vibration reduction on a quadrocopter
S.131-141A major application case for drones is its usage as a flying video camera. Vibration excited by motors and wind reduces the video quality. Therefore passive and active vibration reduction mechanisms as electromotor enhanced gimbals are typically
Wilczynski, D., Bartel, T., Atzrodt, H.
core +1 more source
Structural vibration control using multiple synchronous sources
The advantages of isolating vibrating machinery from its supporting structure are that the chances of vibration induced fatigue failure of structural components are reduced, the structure becomes more inhabitable for people due to less vibration exposure
Dench, M.
core +1 more source
Simulation Study on Ground Vibration Reduction Measures of the Elevated Subway Line
With the development of urban rail transportation, the environmental vibration problem caused by the running of metro vehicles has received attention. In order to reduce ground vibration near buildings caused by metro vehicles running on viaducts, this ...
Hao Wang +5 more
doaj +1 more source
This paper describes a vibration reduction system that can minimize the vertical vibrations of the human body in a vehicle. This system can control the mechanical properties of the seat cushions and seat back cushions, such as the spring constants and ...
Shinichiro OTA, Shuji NISHIYAMA
doaj +1 more source
This article presents the design, modeling, and characterization of air‐pressure–actuated programmable vibroacoustic metamaterials (PVAMM). The study focuses on leveraging air pressure to dynamically tune resonance frequencies for effective noise attenuation.
William Kaal +2 more
wiley +1 more source
Transient vibration analysis of a completely free plate using modes obtained by Gorman's superposition method [PDF]
This paper shows that the transient response of a plate undergoing flexural vibration can be calculated accurately and efficiently using the natural frequencies and modes obtained from the superposition method.
Ilanko, Sinniah, Yusuke, Mochida
core +1 more source
Vibration modes and acoustic noise in a four-phase switched reluctance motor [PDF]
Acoustic noise in the switched reluctance motor (SRM) is caused primarily by the deformation of the stator lamination stack. Acoustic noise is most severe when the periodic excitation of the SRM phases excites a natural vibration mode of the stack.
Miller, T.J.E. +2 more
core +2 more sources

