Results 61 to 70 of about 354,663 (307)
Bevel gearbox fault diagnosis using vibration measurements [PDF]
, 2016 The use of vibration measurementanalysis has been proven to be effective for gearbox fault diagnosis. However, the complexity of vibration signals observed from a gearbox makes it difficult to accurately detectfaults in the gearbox. This work is based on
Chandra +10 more
core +2 more sources
Development of mine-used signal conditioning device of vibration acceleration sensor
Gong-kuang zidonghua, 2014 In view of problem that vibration signal of underground large equipments is difficult to be collected, a mine-used signal conditioning device of vibration acceleration sensor was designed.
JI Xiaodong +3 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.The tribological behavior of 100Cr6 steel spheres textured via Vickers microindentation is evaluated under lubricated sliding by varying both dimple size and density. Fine and dense textures significantly reduce friction across all lubrication regimes, while large dimples increase it.
Farideh Davoodi +3 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.This study presents a reversible temperature sensor with high switching ratio, ∼103. The device is fabricated using PET‐ITO and carbon nanotube dispersions in alkane. Considering its application in cold chain logistics, a proof‐of‐concept with LED is showcased. Thus, a temperature drop below the threshold temperature (crystallization temperature of the
Sunil Kumar Behera +8 more
wiley +1 more source
Vibration signal denoising method for drive roller bearing of mine-used belt conveyor
Gong-kuang zidonghua, 2019 EMD has modal aliasing and ICA requires the number of collected vibration signal should not be less than the number of source signal. In view of the above problems that existed in existing vibration signal denoising method, a vibration signal denoising ...
YANG Xiang +5 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.Powder metal processing provides scalable advantages in nanoporous (np) metal development. Mechanical alloying is used to produce unique precursors for hybrid nanopore formation by oxide reduction and dealloying. As demonstrated in np Ag, this approach improves process efficiency while promoting smaller ligaments and larger pores, both of which are ...
Mark A. Atwater, Oliver A. Fowler
wiley +1 more source
Bolt Detection Signal Analysis Method Based on ICEEMD
, 2018 The construction quality of the bolt is directly related to the safety of the project, and as such, it must be tested. In this paper, the improved complete ensemble empirical mode decomposition (ICEEMD) method is introduced to the bolt detection signal ...
Guo, Chunhui +3 more
core +2 more sources
Modulation instability-induced fading in phase-sensitive optical time-domain reflectometry [PDF]
, 2013 Phase-sensitive optical time-domain reflectometry (?OTDR) is a simple and effective tool allowing the distributed monitoring of vibrations along single-mode fibers.
Corredera Guillén, Pedro +5 more
core +5 more sources
Advanced Engineering Materials, EarlyView.This study demonstrates an efficient recycling route for out‐of‐spec AlSi10Mg atomized powders through compaction and arc remelting followed by suction casting. By correlating compaction load, cooling rate, and resulting microstructure, we show that intermediate pressures (50–80 kN) and rapid cooling refine dendrites, reduce porosity, and enhance ...
Mila Christy de Oliveira +4 more
wiley +1 more source
An improved method for testing performance of vidicons during vibration [PDF]
, 1966 Vidicon electron beam modulation is used for checking the performance of vidicons in mechanical vibration tests. The vidicon electron beam is modulated with an external signal during the write period thereby storing the image on the vidicon ...
Corson, B. R.
core +1 more source