Results 101 to 110 of about 628,094 (302)
Metals, 2020 Adhesive joints between dissimilar layers of metals and composites are increasingly used by different industries, as they promise significant weight savings and, consequently, a reduction in energy consumption and pollutant emissions. In the present work,
Panayiotis Tsokanas +2 more
doaj +1 more source
Vibrations and fractional vibrations of rods, plates and Fresnel pseudo-processes
, 2011 Different initial and boundary value problems for the equation of vibrations of rods (also called Fresnel equation) are solved by exploiting the connection with Brownian motion and the heat equation. The analysis of the fractional version (of order $\nu$)
A. Lachal +26 more
core +1 more source
Advanced Engineering Materials, EarlyView.Disordered (Fe50Co50)1−xPtx thin films exhibit a pronounced anomalous Nernst effect (ANE) with a strong composition dependence on both rigid and flexible substrates. The transverse thermoelectric response peaks near 22.5 at.% Pt, accompanied by enhanced αxy/σxy scaling, thermal transport, and ANE sensitivity.
Mojtaba Mohammadi +2 more
wiley +1 more source
The Scientific World Journal, 2014 A new incus-body driving type transducer relying on piezoelectric stack, with broad frequency bandwidth, is proposed for use in a middle ear implant. To aid the design process of this transducer, a coupling biomechanical model of the human middle ear and
Houguang Liu +5 more
doaj +1 more source
Experiences with nonsynchronous forced vibration in centrifugal compressors [PDF]
The high subsynchronous vibrations which are often forced vibrations caused by flow instabilities, such as stage stall were examined. Modifications to improve the rotor stability by changing the bearings or seals have little effects on the subsynchronous
Smith, D. R., Wachel, J. C.
core +1 more source
Advanced Engineering Materials, EarlyView.The presented study focuses on the fracture behaviour of carbon‐bonded magnesia MgO–C refractories, where environmentally friendly fructose, collagen and lignin serve as temporary binding agents. The partial substitution of the source material with recycled MgO–C reduces the fracture resistance, which can be counteracted by the additional introduction ...
Marc Neumann +6 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.This study investigates thermo‐chemical processes during high‐temperature testing of two commercial MgO‐C brick grades, one containing 47.5 wt.% MgO‐C recyclate. Using ETV, DTA/TG‐MS, XRD, and SEM/EDS/EBSD, mechanisms such as carbothermal reduction of magnesia, impurity incorporation into the secondary MgO surface layer, and calcium‐rich phase ...
Alexander Schramm +6 more
wiley +1 more source
Seismocardiographic Signal Timing with Myocardial Strain
, 2017 Speckle Tracking Echocardiography (STE) is a relatively new method for cardiac function evaluation. In the current study, STE was used to investigate the timing of heart-induced mostly subaudible (i.e., below the frequency limit of human hearing) chest ...
Kakavand, Bahram +3 more
core +1 more source
Thermophysical Properties of the Desulphurization Slags With Various CaS and CaO/Al2O3 Ratio
Advanced Engineering Materials, EarlyView.This article investigates how CaS content and the CaO/Al2O3 ratio influence the thermophysical properties of desulphurization slags. Using experimental measurements and thermodynamic simulations, this study reveals complex effects on viscosity, surface tension, and density, providing new insight into slag structure and phase behavior under ...
Eldar Salpagarov +4 more
wiley +1 more source
Nonlinear Dynamic Analysis of Macrofiber Composites Laminated Shells
Advances in Materials Science and Engineering, 2017 This work presents the nonlinear dynamical analysis of a multilayer d31 piezoelectric macrofiber composite (MFC) laminated shell. The effects of transverse excitations and piezoelectric properties on the dynamic stability of the structure are studied ...
Xiangying Guo +4 more
doaj +1 more source