Results 1 to 10 of about 440 (181)

Fatigue safety factor of a transonic centrifugal compressor impeller subject to blade thickness [PDF]

Scientific Reports
This sensitivity study is focused on understanding the rate at which blade thickness can affect the risk of high-cycle fatigue failure in an impeller of a centrifugal compressor.
Kirill Kabalyk, Arkadiusz Bednarz, Krzysztof Kantyka   +2 more
doaj   +2 more sources

One-dimensional flame instability and control of burning in fire-chamber

Trudy Odesskogo Politehničeskogo Universiteta, 2015
The flame stability with regard to one-dimensional exponential perturbations both for the combustion in the fire-chamber and the flame propagating in closed tubes or chambers is investigated. It is proved that both stability and instability are possible
Віктор Едуардович Волков
doaj   +7 more sources

TWO-DIMENSIONAL FLAME INSTABILITY AND CONTROL OF BURNING IN THE HAlF-OPEN FIRECHAMBER

Автоматизация технологических и бизнес-процессов, 2016
The flame stability with regard to two-dimensional exponential perturbations both for the combustion in the half-open fire-chamber and the flame propagating in half-open channels is investigated.
V. E. Volkov
doaj   +1 more source

SHS Joining Via Combustion of Ti-Containing Systems

Eurasian Chemico-Technological Journal, 2013
The joining of intermetallic parts to the metals (Ti, Al, Cu, Ni) or different intermetallics (e.g. NiAl, TiAl) is important for high-temperature applications.
O. D. Boyarchenko, S. G. Vadchenko, N. V. Sachkova, A. E. Sytschev   +3 more
doaj   +1 more source

The Effect of Non-Circular Bearing Shapes in Hydrodynamic Journal Bearings on the Vibration Behavior of Turbocharger Structures

Lubricants, 2017
Increasing quality demands of combustion engines require, amongst others, improvements of the engine’s acoustics and all (sub)components mounted to the latter. A significant impact to the audible tonal noise spectrum results from the vibratory motions of
Lukas Bernhauser, Martin Heinisch, Markus Schörgenhumer, Manfred Nader   +3 more
doaj   +1 more source

Vibration transmitted to operator’s back by machines with back-pack power unit: a case study on blower and spraying machines

Journal of Agricultural Engineering, 2013
To correctly evaluate the vibration transmitted to the operators, it is necessary to consider each body’s point interested by the vibratory stimulus produced by machines.
Roberto Deboli, Angela Calvo, Venerando Rapisarda, Christian Preti, Marco Inserillo   +4 more
doaj   +1 more source

Vibration Analysis for Diagnosis of Diesel Engines with Air Flow Sensor Failure

Technologies
Carrying out automobile stability and dynamic comfort involves a close examination of engine performance, such that fault detection at the early stage must be of the highest priority to reliability and effectiveness.
Ali Helali, Ines Belkacem, Jamila Abdellaoui, Achraf Zegnani   +3 more
doaj   +1 more source

Recycling of Mo and V from Spent Hydrogenation Catalysts via a One-Step Soda-Roasting Process. [PDF]

ACS Omega
Wang W, Shi Z, Yuan C, Ma B, Sun G, Liu G.   +5 more
europepmc   +1 more source

Visualization of Combustion Phases of Biomass Particles: Effects of Fuel Properties. [PDF]

ACS Omega, 2021
Jia Y, Li Z, Wang Y, Wang X, Lou C, Xiao B, Lim M.   +6 more
europepmc   +1 more source

Structural Vibration Analysis of UAVs Under Ground Engine Test Conditions. [PDF]

Sensors (Basel)
González-Cabrera SI, Camacho-Zamora N, Rojas-Ramirez SR, Gonzalez-Aguilar AM, Vigueras-Zuniga MO, Tejeda-Del-Cueto ME.   +5 more
europepmc   +1 more source