Linear-log counting-rate meter uses transconductance characteristics of a silicon planar transistor [PDF]
, 1969 Counting rate meter compresses a wide range of data values, or decades of current. Silicon planar transistor, operating in the zero collector-base voltage mode, is used as a feedback element in an operational amplifier to obtain the log ...
Eichholz, J. J.
core +1 more source
Voltage-Mode Multifunction Biquadratic Filters Using New Ultra-Low-Power Differential Difference Current Conveyors [PDF]
, 2013 This paper presents two low-power voltage-mode multifunction biquadratic filters using differential difference current conveyors. Each proposed circuit employs three differential difference current conveyors, two grounded capacitors and two grounded ...
Dejhan, K. +4 more
core +1 more source
Voltage-Mode Highpass, Bandpass, Lowpass and Notch Biquadratic Filters Using Single DDCC [PDF]
, 2012 A new voltage-mode multifunction biquadratic filter using one differential difference current conveyor (DDCC), two grounded capacitors and three resistors is presented.
Chiu, W. Y., Horng, J. W.
core +1 more source
An ultra-low-power voltage-mode asynchronous WTA-LTA circuit [PDF]
, 2013 This paper presents an asynchronous mixed-signal WTA-LTA circuit conceived to carry out local minimummaximum indexing in massively parallel image processing arrays. The hardware is focused on energy-efficient operation.
Carmona Galán, Ricardo +2 more
core +1 more source
, 2014 Speed is a major concern for high density VLSI networks. In this paper the closed form delay model for current mode signalling in VLSI interconnects has been proposed with resistive load termination. RLC interconnect line is modelled using characteristic
Chandel, Rajeevan +2 more
core +1 more source
Control analysis and experimental verification of a practical dc–dc boost converter
Journal of Electrical Systems and Information Technology, 2015 This paper presents detailed open loop and closed loop analysis on boost dc–dc converter for both voltage mode control and current mode control. Here the boost dc–dc converter is a practical converter considering all possible parasitic elements like ESR ...
Saswati Swapna Dash, Byamakesh Nayak
doaj +1 more source
Electronically Tunable Resistorless Mixed Mode Biquad Filters [PDF]
, 2013 This paper presents a new realization of elec¬tronically tunable mixed mode (including transadmittance- and voltage-modes) biquad filter with single input, three outputs or three inputs, single output using voltage differ-encing transconductance ...
Kacar, F., Yesil, A.
core +1 more source
5 Gbit/s 2‐tap low‐swing voltage‐mode transmitter with least segmented voltage‐mode equalisation
Electronics Letters, 2014 A 2‐tap low‐swing voltage‐mode transmitter which compensates the loss of channel at high frequency is proposed. The output driver of the proposed 2‐tap transmitter consists of only two voltage‐mode drivers, and thereby the design complexity of the pre‐driver is greatly reduced compared with that of conventional 2
Kang‐Sub Kwak +2 more
openaire +1 more source
Maximum Effectiveness of Electrostatic Energy Harvesters When Coupled to Interface Circuits
, 2012 Accepted ...
Green, TC, Mitcheson, PD
core +1 more source
Comparison of single-phase matrix converter and H-bridge converter for radio frequency induction heating [PDF]
, 2007 This paper compares the newly developed single-phase matrix converter and the more conventional H- bridge converter for radio frequency induction heating.
Bingham, Chris +3 more
core +1 more source