Results 11 to 20 of about 75 (70)
Surrogate Assisted Optimization for Low-Voltage Low-Power Circuit Design
Journal of Low Power Electronics and Applications, 2020 Low-voltage low-power (LVLP) circuit design and optimization is a hard and time-consuming task. In this study, we are interested in the application of the newly proposed meta-modelling technique to alleviate such burdens.
Amel Garbaya +3 more
doaj +1 more source
SensorsThis paper presents electronically tunable current conveyors using low-voltage, low-power, multiple-input operational transconductance amplifiers (MI-OTAs). The MI-OTA is realized using the multiple-input bulk-driven Metal Oxide Semiconductor transistor (
Montree Kumngern +3 more
doaj +1 more source
Control system for a frequency synchronized asynchronous electric drive
Известия высших учебных заведений: Проблемы энергетики, 2021 THE PURPOSE. In controlled AC drives used on continuous-action mechanisms, which include conveyors, conveyors, cranes, the most widespread are asynchronous motors with a phase rotor, controlled mainly along the rotor circuit using various regulators with
V. N. Meshcheryakov +3 more
doaj +1 more source
Supplementary High-Input Impedance Voltage-Mode Universal Biquadratic Filter Using DVCCs
Modelling and Simulation in Engineering, 2012 To further extend the existing knowledge on voltage-mode universal biquadratic filter, in this paper, a new biquadratic filter circuit with single input and multiple outputs is proposed, employing three differential voltage current conveyors (DVCCs ...
Jitendra Mohan, Sudhanshu Maheshwari
doaj +1 more source
Voltage-Controlled Square/Triangular Wave Generator with Current Conveyors and Switching Diodes
International Journal of Advances in Telecommunications, Electrotechnics, Signals and Systems, 2012 A novel relaxation oscillator based on integrating the diode-switched currents and Schmitt trigger is presented. It is derived from a known circuit with operational amplifiers where these active elements were replaced by current conveyors.
Martin Janecek +2 more
doaj +1 more source
Sensors, 2022 This paper presents four new designs for a first-order voltage-mode (VM) all-pass filter (APF) circuit based on two single-output positive differential voltage current conveyors (DVCCs).
Hua-Pin Chen +5 more
doaj +1 more source
Implementation of a Double-Path Flipped Voltage Follower Cell for Voltage Conveyors
IEEE AccessThis paper presents a low-power class-AB second-generation voltage conveyor (VCII) based on a new high-drive flipped voltage follower (FVF) circuit. The proposed FVF cell establishes an additional negative feedback loop to enhance the driving capability ...
Meysam Akbari, Kea-Tiong Tang
doaj +1 more source
DDCC-Based Quadrature Oscillator with Grounded Capacitors and Resistors
Active and Passive Electronic Components, 2009 A new voltage-mode quadrature oscillator using two differential difference current conveyors (DDCCs), two grounded capacitors, and three grounded resistors is presented. The proposed oscillator provides the following advantages: the oscillation condition
Montree Kumngern, Kobchai Dejhan
doaj +1 more source
A Novel Electronic Interface for Micromachined Si-Based Photomultipliers
Micromachines, 2018 In this manuscript, the authors propose a novel interface for silicon photomultipliers based on a second-generation voltage conveyor as an active element, performing as a transimpedance amplifier.
Leonardo Pantoli +4 more
doaj +1 more source
A Current-Mode TransImpedance Amplifier for Capacitive Sensors
Proceedings, 2018 A Current-Mode (CM) TransImpedance Amplifier (TIA) based on Second Generation Current Conveyors (CCIIs) for capacitive microsensor measurements is presented. The designed electronic interface performs a capacitance-to-voltage conversion using 3 CCIIs and
Alessandro Nastro +3 more
doaj +1 more source