Results 11 to 20 of about 915,622 (300)
New Smart Sensor for Voltage Unbalance Measurements in Electrical Power Systems
Sensors, 2022 This paper deals with voltage unbalances and how they can be quantified according to the standards. Firstly, a comparison between the different unbalance voltage factors is conducted in order to remark on their divergences.
Santiago Bogarra +2 more
doaj +1 more source
IEEE Open Journal of Power Electronics, 2022 This paper investigates the effect of voltage sensors on the measurement of transient voltages for power semiconductors in a Double Pulse Test (DPT) environment.
Sebastian Sprunck +3 more
doaj +1 more source
Reducing AC impedance measurement errors caused by the DC voltage dependence of broadband high-voltage bias-tees [PDF]
, 2007 During the AC impedance characterization of devices, from the kHz-range up to the GHz-range, accuracy can be lost when a DC voltage is applied. Commercial high-voltage broadband bias-tees are often voltage-dependent, which can cause inaccuracies at low ...
Reimann, K. +2 more
core +2 more sources
Elektronika ir Elektrotechnika, 2020 This article deals with the development of capacitive voltage divider for high voltage measurements and presents a method of analysis and optimization of its parameters.
Roman Hrbac +5 more
doaj +1 more source
Fast RF-CV characterization through high-speed 1-port S-parameter measurements [PDF]
, 2010 We present a novel method to measure the capacitance-voltage relation of an electronic device. The approach is accurate, very fast, and cost-effective compared to the existing off-the-shelf solutions.
Herfst, R.W. +4 more
core +3 more sources
Comparative high voltage impulse measurement
Journal of Research of the National Institute of Standards and Technology, 1996 A facility has been developed for the determination of the ratio of pulse high voltage dividers over the range from 10 kV to 300 kV using comparative techniques with Kerr electro-optic voltage measurement systems and reference resistive voltage dividers. Pulse voltage ratios of test dividers can be determined with relative expanded uncertainties of 0.4
FitzPatrick, Gerald J. +1 more
openaire +2 more sources
A Design of PWM Controlled Calibrator of Non-Sinusoidal Voltage Waveforms
Energies, 2019 Power quality conditions in electrical power networks have drastically changed in recent years. A number of electrical devices and power generators that are the main sources of disturbances is ever increasing.
Goran Petrovic +3 more
doaj +1 more source
Electrostatic force spectroscopy of near-surface localized states [PDF]
, 2004 Electrostatic force microscopy at cryogenic temperatures is used to probe the electrostatic interaction of a conductive atomic force microscopy tip and electronic charges trapped in localized states in an insulating layer on a semiconductor.
Dana, Aykutlu, Yamamoto, Yoshihisa
core +2 more sources
A subsystem‐based fault location method in distribution grids by sparse measurement
IET Generation, Transmission & Distribution, 2023 With the development of smart meters and other intelligent electronic devices, more and more data‐driven fault location methods based on wide area measurement are emerging.
Xiaodong Lv +5 more
doaj +1 more source
Sensors, 2021 The reliable and cost-effective condition monitoring of the bearings installed in water pumps is a real challenge in the industry. This paper presents a novel strong feature selection and extraction algorithm (SFSEA) to extract fault-related features ...
Muhammad Irfan +8 more
doaj +1 more source