Results 231 to 240 of about 859,052 (299)

Exploring the synergic effect of thermal tuning and mode-coupling for frequency stabilization in micromechanical resonators. [PDF]

Microsyst Nanoeng
Xiao Y, Sun C, Liu S, Wu G.
europepmc   +1 more source

Triboelectric horology: escapement-inspired design strategy for prolonged energy harvesting under irregular mechanical inputs. [PDF]

Microsyst Nanoeng
Lee D, Ju S, Park DY, Kwon S, Jeong YW, Choi M, Lee S, Kim YS, Cho S, Kam D, Lin ZH, Choi D.   +11 more
europepmc   +1 more source

Solid oxide fuel cell simulation model tuning using operating conditions dependent optimization techniques. [PDF]

Sci Rep
Hesham H, Abdel Rahman M, Bassioni G, Swief RA, Ezzat M, Helmy S, Elbehairy NM.   +6 more
europepmc   +1 more source

A Highly Linear Analog-to-Spike Converter

Akbari M, Covi E.
europepmc   +1 more source

Some of the next articles are maybe not open access.

Related searches:

Voltage power line conditioner - voltage restoring mode

2005 European Conference on Power Electronics and Applications, 2005
This paper describes the modified structure of voltage source power line conditioner. The principals of operation and basic properties in voltage restoring mode have been introduced. Some simulation results in typical disturbance of distribution network voltage cases have been obtained and discussed.
R. Strzelecki, G. Benysek, K. Sozanski, M. Jarnut, J. Rusinski   +4 more
openaire   +1 more source

Sleep-Mode Voltage Scaling

ACM Transactions on Embedded Computing Systems, 2016
In heavily duty-cycled embedded systems, the energy consumed by the microcontroller in idle mode is often the bottleneck for battery lifetime. Existing solutions address this problem by placing the microcontroller in a low-power (sleep) mode when idle and preserving application state either by retaining the data
Hrishikesh Jayakumar, Arnab Raha, Vijay Raghunathan   +2 more
openaire   +1 more source

Voltage-mode defuzzification circuits

International Journal of Electronics, 1994
The defuzzification interface is an important building block of a fuzzy logic controller (FLC). In this paper we describe two major methods for defuzzification and suitable analogue implementations for voltage-mode operation. A full rail-to-rail voliage range can be obiained using a fixed gain amplifier. SPICE simulations are presenied for each circuit.
ION E. OPRlS, GREGORY T. A. KOVACS
openaire   +1 more source

Current-Mode Filters Using Voltage Amplifiers

Circuits, Systems & Signal Processing, 2007
zbMATH Open Web Interface contents unavailable due to conflicting licenses.
Raut, R., Swamy, M. N. S., Tian, Nong
openaire   +1 more source

Failure Modes during Low-Voltage Electrowetting

ACS Applied Materials & Interfaces, 2016
Low-voltage electrowetting devices allow significant contact angle changes below a 50 V bias; however, operation under prolonged cycling and failure modes have not yet been sufficiently elucidated. In this work, the failure modes and performance degradation of Cytop (23-210 nm)/aluminum oxide (15-44 nm) bilayers have been investigated.
Marcel, Mibus, Xiaoyu, Hu, Carl, Knospe, Michael L, Reed, Giovanni, Zangari   +4 more
openaire   +2 more sources