Results 21 to 30 of about 27,555 (281)
Synthesis of active LTV elements
Archives of Electrical Engineering, 2020 The article proposes the method of synthesis of active elements with time-varying parameters R(t), C(t) and L(t). In order to construct the elements, it is necessary to use operational amplifiers, multipliers and classic RLC components.
Anna Piwowar, Janusz Walczak
doaj +1 more source
A processing element architecture for high-density focal plane analog programmable array processors [PDF]
, 2002 The architecture of the elementary Processing Element - PE- used in a recently designed 128×128 Focal Plane Analog Programmable Array Processor is presented.
Domínguez Castro, Rafael +3 more
core +1 more source
Novel immense configurations of boost converter for renewable energy application
The Journal of Engineering, 2019 A three-immense configurations of boost converter for renewable energy application is presented here. The voltage lift switched inductor (VLSI) structure is pledged to extra high-voltage conversion.
Pandav Kiran Maroti +4 more
doaj +1 more source
High step-up interleaved boost converter utilising stacked half-bridge rectifier configuration
The Journal of Engineering, 2019 This paper proposes a solution to complement the insufficient voltage gain and voltage stress distribution of classical interleaved boost converter in high step-up application.
Musbahu Muhammad +3 more
doaj +1 more source
Multiple Input-Terminal Voltage Multiplier Circuit [PDF]
2019 4th International Conference on Intelligent Green Building and Smart Grid (IGBSG), 2019 Voltage multipliers (VMs) are widely used not only in high voltage gain rectifier applications but also some traditional dc/dc converters to improve voltage conversion ratio. However, as the fixed number of its input-terminals, it is hard to traditional VM circuits to make a balance between the voltage and current stress on capacitors.
Binxin Zhu +3 more
openaire +3 more sources
A Breakdown Voltage Multiplier for High Voltage Swing Drivers [PDF]
IEEE Journal of Solid-State Circuits, 2007 A novel breakdown voltage (BV) multiplier is introduced that makes it possible to generate high output voltage swings using transistors with low breakdown voltages. The timing analysis of the stage is used to optimize its dynamic response. A 10 Gb/s optical modulator driver with a differential output voltage swing of 8V on a 50 Omega load was ...
Mandegaran, Sam, Hajimiri, Ali
openaire +2 more sources
ACE16K: The Third Generation of Mixed-Signal SIMD-CNN ACE Chips Toward VSoCs [PDF]
, 2004 Today, with 0.18-μm technologies mature and stable enough for mixed-signal design with a large variety of CMOS compatible optical sensors available and with 0.09-μm technologies knocking at the door of designers, we can face the design of integrated ...
Carmona Galán, Ricardo +7 more
core +1 more source
Low voltage CMOS four-quadrant multiplier [PDF]
Electronics Letters, 1994 A new CMOS four-quadrant multiplier that can operate from supply voltages of /spl plusmn/1.5 V is presented. This circuit was fabricated in a standard 0.8 /spl mu/m single-poly double-metal CMOS process. Experimental results show that the nonlinearity can be kept
null Liu, null Chang
openaire +2 more sources
Comparative Analysis of High-Voltage High-Frequency Pulse Generation Techniques for Pockels Cells
Applied SciencesThis paper presents a comprehensive comparative analysis of high-voltage, high-frequency pulse generation techniques for Pockels cell drivers. These drivers are critical in electro-optic systems for laser modulation, where nanosecond-scale voltage pulses
Edgard Aleinikov, Vaidotas Barzdenas
doaj +1 more source
An Overview of Non-Isolated Hybrid Switched-Capacitor Step-Up DC–DC Converters
Applied Sciences, 2022 The increasing interest in renewable energy sources has brought attention to large voltage-gain dc–dc converters; among the different available solutions to perform a large voltage-gain conversion, this article presents an overview of non-isolated dc–dc ...
Julio C. Rosas-Caro +5 more
doaj +1 more source