Results 21 to 30 of about 2,449,004 (304)
Bifurcation processes in pulse voltage regulator
Analysis of a pulse voltage regulator from the point of view of transition to an unstable position and possible bifurcation states. Calculation of the stability condition when changing the parameters of the system.
Danil L. Myasnikov, Yulia V. Sokolova
doaj +1 more source
The modern electronic device should be able to provide stable voltage and current under a variety of conditions. The LDO regulator used in the electronic device is a system that requires various voltages and load currents.
Sang-Wook Kwon, Yong-Seo Koo
doaj +1 more source
The intelligent, robust and reliable control of Automatic Voltage Regulator is essential to maintain a constant voltage level of synchronous generator working under different operating conditions.
I. Eke +4 more
semanticscholar +1 more source
Reliability Analysis of Capacitors in Voltage Regulator Modules With Consecutive Load Transients
Capacitors are critical in voltage regulator modules (VRMs), which contribute to store energy and stabilize the output voltage during load transients. Usually, VRMs work with consecutive load transients, which would bring more electrothermal stress to ...
Zhaoyang Zhao +4 more
semanticscholar +1 more source
Design Voltage Regulator for Synchronous Generator [PDF]
As the loud on an alternator is varied, its terminal voltage is also found tovary. This variation terminal voltage is due to voltage drop in armature(resistance, leakage reactance) and armature reaction, therefore thisresearch aim to design voltage ...
Rifaat A. Jaafar +3 more
doaj +1 more source
The integration of renewable distributed generation (RDG) into distribution networks is promising and increasing nowadays. However, high penetration levels of distributed generation (DG) are often limited as they may have an adverse effect on the ...
Ahmed S.A. Awad +2 more
doaj +1 more source
Overview on Latch-Up Prevention in CMOS Integrated Circuits by Circuit Solutions
In CMOS chips, the wider layout rules were traditionally applied to overcome latch-up issues. However, the chip area with wider layout rules was often enlarged, and in turn the chip cost was also increased.
Ming-Dou Ker, Zi-Hong Jiang
doaj +1 more source
Research on coordinated control of flexible on-load voltage regulator and STATCOM
Traditional on-load tap changer (OLTC) has problems such as easy oscillation and low regulation precision in the voltage regulation control of the power system.
Qiran Liu +5 more
doaj +1 more source
In the literature, all investigations dealing with regulator design in the AVR loop observe the AVR system as a single input single output (SISO) system, where the input is the generator reference voltage, while the output is the generator voltage ...
Sultan Alghamdi +7 more
doaj +1 more source
Switched Inductor DC–DC Boost Regulator Using Voltage-to-Time Controller for TEG Applications
This paper presents a switched inductor (SI) DC–DC boost regulator designed for thermoelectric generator (TEG) applications. To boost and regulate the output voltage, two feedback loops are implemented which control the duty cycle of the SI clock.
Dima Kilani +2 more
doaj +1 more source

