Results 21 to 30 of about 1,475,070 (295)
Wetting and spreading of surfactant solutions play an important role in many technical applications. In printing processes, the size of individual droplets is typically on the order of a few tens of microns.
Thomas Antritter +4 more
doaj +1 more source
Under a high Schmidt number condition, concentration boundary layers get much thinner than momentum boundary layers. Resolution requirement to numerically capture the steep concentration gradient near an interface is therefore significantly high.
Rihito ADACHI +2 more
doaj +1 more source
Adjoint complement to the volume-of-fluid method for immiscible flows [PDF]
The paper is concerned with an adjoint complement to the Volume-of-Fluid (VoF) method for immiscible two-phase flows, e.g. air and water, which is widely used in marine engineering due to its computational efficiency. The particular challenge of the primal and the corresponding adjoint VoF-approach refers to the sharp interface treatment featuring ...
Kühl, Niklas +4 more
openaire +3 more sources
In this paper, computational modeling of wave generation and evaluation of results are given. The analysis of Computational Fluid Dynamics is performed in the ANSYS Fluent module. The model of numerical analysis is made time-dependent. The Numerical Wave
Taner Yılmaz +2 more
doaj +1 more source
A minimal model for acoustic forces on Brownian particles [PDF]
We present a generalization of the inertial coupling (IC) [Usabiaga et al. J. Comp. Phys. 2013] which permits the resolution of radiation forces on small particles with arbitrary acoustic contrast factor.
Delgado-Buscalioni, R. +1 more
core +2 more sources
Droplet impact on a substrate is an intriguing phenomenon that widely exists in our daily life and a broad range of industrial processes. However, droplet impact dynamics on soft textured surfaces are less explored and the underlying mechanisms remain ...
Yang Li, Jiangtao Cheng
doaj +1 more source
A combined experimental and computational fluid dynamics analysis of the dynamics of drop formation [PDF]
This article presents a complementary experimental and computational investigation of the effect of viscosity and flowrate on the dynamics of drop formation in the dripping mode.
Chen H. H. +5 more
core +1 more source
A three-dimensional hydrodynamic model is developed to study the propagation of dam-break-induced flood and the interaction between floods and buildings.
Chinghao Yu +3 more
doaj +1 more source
Benchmark Study of FINETM/Marine CFD Code for the Calculation of Ship Resistance
Benchmarking can be used to test CFD programs for selecting turbulence models, grid dependency studies, testing different numerical schemes and source codes, and testing different boundary conditions.
Ahmad Firdhaus +3 more
doaj +1 more source
Experimental and numerical investigation of dam break flow propagation passed through complex obstacles using LES model based on FVM and LBM [PDF]
Dam break analysis plays a key role in hydraulics engineering for safety. In this paper, 3D numerical simulations of dam-break flow using Finite Volume and Lattice Boltzmann methods are studied and discussed.
Chartchay Chumchan +1 more
doaj +1 more source

