Results 201 to 210 of about 30,504 (243)
Some of the next articles are maybe not open access.
Broad-band VSWR measurements of a Cassegrain antenna
IEEE Transactions on Antennas and Propagation, 1978Broadband VSWR measurements are reported on a small F -number Cassegrain antenna. Cyclical variations of VSWR between 1.00 and 1.25 with a 350-MHz frequency interval between unity VSWR values were observed over the 8.5-12.4 GHz frequency range. These variations correspond to a change in the power transmission ratio of 1.231 percent between the unity ...
W. Nunn, M. Figueroa
openaire +1 more source
Automatic site-VSWR measurement using mobile robot platform
2014 International Symposium on Electromagnetic Compatibility, 2014We have developed an automatic site-VSWR (SVSWR) measurement system using a mobile robot platform and an optical microwave transmitter. The proposed system can rapidly evaluate the performance of EMI anechoic chambers. In this paper, we explain the SVSWR measurement results obtained with the proposed system and the device configuration.
Michitaka Ameya, Satoru Kurokawa
openaire +1 more source
Transmitting Antenna VSWR Effects on FM Stereo
IEEE Transactions on Broadcasting, 1963The effects of antenna VSWR on stereo left-right channel separation of a FM broadcasting station were investigated. The results of these tests were significant and indicate that the transmitting antenna VSWR for ±200 KC must be low. They also indicate that if the rest of the system from studio to the output of the stereo receiver is fixed, a change in ...
openaire +1 more source
VSWR-protected 90 W L-band AlGaN/GaN power amplifier
2014 IEEE MTT-S International Microwave Symposium (IMS2014), 2014Solid-state power amplifiers need protection against reflected power at the output caused by load mismatch. The standard method for protection is to include a ferrite-based isolator at the output. The isolator will redirect all reflected power to a dissipating load resistor and will ensure that the output of the amplifier always sees a 50 Ω load ...
Heijningen, M. van de +4 more
openaire +2 more sources
Traceable Site-VSWR Measurements for Validating Anechoic Chamber
2018 Conference on Precision Electromagnetic Measurements (CPEM 2018), 2018This paper presents recent works on traceable site-VSWR (Voltage Standing Wave Ratio) measurements for validating RF semi-anechoic chamber in 1 GHz – 18 GHz, in accordance with CISPR (International Special Committee on Radio Interference) 16-1-4 technical standard.
Yu Song Meng, Junhong Deng, Yueyan Shan
openaire +1 more source
Coaxial Swept-Frequency VSWR Measurements Using Slotted Lines
IEEE Transactions on Instrumentation and Measurement, 1968A system is described using a sweep generator, a slotted line with a broad-band probe, a sliding load which can be coupled mechanically to the probe carriage, a logarithmic amplifier, and a read-out device which can measure the VSWR of coaxial components continuously versus frequency.
openaire +1 more source
Influences of CUT on the VSWR of GTEM Cell
2009 20th International Zurich Symposium on Electromagnetic Compatibility, 2009The GTEM cell method to measuring shielding effectiveness is accepted by ANSI/SCTE48-3 2004, but there is no analysis of the influences of the introduction of cable under test(CUT) on the VSWR of GTEM cell, which will result in measure error. The influences of the size, position, shape and direction of CUT is analyzed by simulation, and the influences ...
Xiang Zhou +2 more
openaire +1 more source
Aircraft ATC Antenna VSWR On-wing Tester
2014The reason of the ATC antenna failure is mostly the mismatch of the ATC transponder output impedance with the ATC Antenna impedance. The mismatch causes the increasement of the Voltage Standing Wave Ratio (VSWR) and the severe low efficiency of the emission (receive), then the ATC/TCAS system cannot working normally.
openaire +1 more source
Precision Coaxial VSWR Measurements by Coupled Sliding-Load Technique
IEEE Transactions on Instrumentation and Measurement, 1964The method described employs a slotted line for VSWR measurement and a precision coaxial line as an impedance standard. A sliding load terminates the standard line during the process of transforming the impedance of the slotted line to that of the standard line.
B. O. Weinschel +3 more
openaire +1 more source
GaN-HEMT VSWR Ruggedness and Amplifier Protection
2010This paper presents the initial results in a study aimed at exploring the use of GaN-devices in applications where they are at risk of being exposed to high output voltage-standing-wave-ratio (VSWR) conditions. A measurement method developed to identify the limits of such stress is described together with the first results from measurements of novel ...
Bengtsson, O. +5 more
openaire +1 more source