Results 41 to 50 of about 7,015,582 (266)
Analysis of Microstructure and Low Permeability with 3D Digital Rock Modeling
Geofluids, 2022 The sandstone microstructure and permeability are important parameters for quantitative evaluation of groundwater/oil/gas resources and prediction of flow rates of water/oil/gas. In this study, we applied seven low-permeability sandstone samples obtained
Jinsui Wu +7 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.A simplified thermoplastic pultrusion model is developed to predict thermal fields in glass fiber/polyethylene terephthalate (GF/PET) composites with reduced computational cost. By combining effective material homogenization, validation against literature data, and Gaussian‐process‐based optimization, the study reveals how heating limits, pulling speed,
Elder Soares +3 more
wiley +1 more source
Dissolution of a Carbon Dioxide Bubble in a Vertical Pipe
Journal of Fluid Science and Technology, 2008 Dissolution of single carbon dioxide (CO2) bubbles in a vertical pipe of 25 mm diameter is measured to examine the effects of the ratio λ of the sphere-volume equivalent bubble diameter to the pipe diameter, the liquid Reynolds number and ...
Satoru ABE +3 more
doaj +1 more source
High ice water content at low radar reflectivity near deep convection – Part 2: Evaluation of microphysical pathways in updraft parcel simulations [PDF]
Atmospheric Chemistry and Physics, 2015 The aeronautics industry has established that a threat to aircraft is posed by atmospheric conditions of substantial ice water content (IWC) where equivalent radar reflectivity (Ze) does not exceed 20–30 dBZ and supercooled water is not present ...
A. S. Ackerman +6 more
doaj +1 more source
Journal of Marine Science and Engineering, 2023 The support pressure on an excavation surface is a critical factor in the ground deformation and excavation stability of a submarine shield tunnel.
Qian Wang +3 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.Scandium (Sc)‐doped AlCoCrFeMo HEA coatings are fabricated via flame spraying with 0.1, 0.3, and 0.5 wt% Sc additions. Among these, the HEA‐Sc0.3 coating exhibits the highest corrosion resistance, indicated by a more positive corrosion potential and lower current density.
Pankaj Kumar +7 more
wiley +1 more source
Diameter discrepancy and treatment accuracy in external beam radiotherapy [PDF]
Nuclear Technology and Radiation Protection, 2012 One of the most problematic elements of radiation therapy is the determination of contour data or treatment depth which may vary due to various parameters. The provision of this data is crucial for treatment calculations and setup.
Moghaddam Ghanbar Behnaz +1 more
doaj +1 more source
Sensors, 2021 A key aspect of urban blasting engineering is evaluating the safety of the blasting dynamic load on the adjacent high-density polyethylene water supply pipeline and controlling the negative impact of the blasting vibration load on the pipeline. According
Nan Jiang +4 more
doaj +1 more source
Polish Journal of Medical Physics and Engineering, 2023 Abstract Introduction: To develop an in-house acrylic-based step-wedge phantom with several thickness configurations for calibrating computed tomography (CT) localizer radiographs in order to measure the water-equivalent diameter (D w ) and the size ...
Sitti M Rif’ah +5 more
openaire +1 more source
Advanced Engineering Materials, EarlyView.Near‐surface deuterium enrichment profiles for different microstructural types of TiAl after exposure at 700 °C in a heavy water‐containing environment. The deuterium levels are significantly higher than expected from natural occurrence, indicating that the heavy water dissociated during the exposure treatment and entered the specimens.
Jonathan D. H. Paul +5 more
wiley +1 more source