Results 241 to 250 of about 523,256 (303)
Some of the next articles are maybe not open access.
Water adsorption in ion-bearing nanopores
The Journal of Chemical Physics, 2007Grand canonical Monte Carlo simulations are used to examine the adsorption of water into cylindrical nanopores containing single ions. The isotherms for water adsorbing into nanopores with radii of 0.44, 0.54, 0.64, and 0.74nm and containing Na+, K+, Ca2+, Cl−, or F− at 298K are computed.
G, Lakatos, G N, Patey
openaire +2 more sources
Transition elements in water-bearing silicate glasses/melts. part II. Ni in water-bearing glasses
Geochimica et Cosmochimica Acta, 2001Abstract The local coordination environment around Ni(II) in a series of sodium trisilicate (NS3) and albitic (ALB) glasses has been evaluated by using high-resolution XANES and anharmonic EXAFS spectroscopies. The glasses contain ∼1000 to 4000 ppm of Ni and from 0 to 8.2 wt.% water.
Farges, F +7 more
openaire +2 more sources
Water-bearing basic rock systems
1979The effects of water on the phase relations of silicate systems are profound, as examples discussed in Chapter 5 have demonstrated. In this chapter the discussion of basaltic and peridotitic phase relations is amplified in the light of experiments on water-bearing systems.
K. G. Cox, J. D. Bell, R. J. Pankhurst
openaire +1 more source
Water-Lubricated Soft-Rubber Bearings
Journal of Fluids Engineering, 1932Abstract Rubber bearings lubricated with water are found to have remarkably low coefficients of friction and to give excellent service under many conditions. The softness of the rubber makes these bearings stand up in the presence of sand and grit, and it also makes the laws of lubrication governing these bearings differ from the ...
W. F. Busse, W. H. Denton
openaire +1 more source
Water lubrication of phenolic bearings
Scientific Lubrication, 1949PHENOLIC bearings have frequently been used P for roll mills, thrust collars and rings, lifter bearings, side bearings on brass mills, plate mills and sheet mills, etc. They have sometimes replaced lignum vitae for marine propellor shaft bearings. Their lubrication can be effectively accomplished with water which, obviously, is the best coolant.
openaire +1 more source