Results 211 to 220 of about 6,599,650 (377)
Experimental Investigation of Microbubble Evolution in the Liquivac Multiphase Flow Pump
ABSTRACT This paper aims to experimentally investigate the mechanisms of microbubble characteristics evolution within an axial pump. The findings will aid in assessing the pump performance by identifying the range of bubble sizes and comparing them with the threshold size (< 300 μm). This study also provides evidence supporting the use of such pumps as
Hamad FA +4 more
wiley +1 more source
Water-pipe Tobacco Components and their Association with Oxidative Stress. [PDF]
Norouzi A, Dehghani T, Eftekhar E.
europepmc +1 more source
ABSTRACT A specific microporous KOH/activated‐biochar (K/BC) was produced from a blend of date stones (DS) and walnut shells (WS) and used in the adsorptive desulfurization (ADS) of two types of model fuel DBT/n‐hexane (S‐hex), DBT/cyclohexane (S‐cyclohex).
Ameen L. Alyawer +4 more
wiley +1 more source
Development of a low-cost, electricity-generating Rankine cycle, alcohol-fuelled cooking stove for rural communities [PDF]
This article describes a novel design and construction of a helical tube flash boiler that uses a 2kW nominal methylated spirit burner to heat an approximately 2.5m long coil of copper pipe fed by a nominal 8 bar electrically operated solenoid water pump.
Hann, D., Kisha, W., Riley, P. H.
core
ABSTRACT Corrosion of metallic process equipment in chemical, marine, and offshore industries leads to significant maintenance costs and safety concerns. Conventional epoxy coatings, though widely applied, often deteriorate under harsh conditions due to microcracking, moisture ingress and lack of self‐healing capability.
Thean Nam Low +5 more
wiley +1 more source
Observation of EAS using a large water tank [PDF]
Using a large water tank (30 m in diameter, 4.5 m in depth) transition of extensive air showers (EAS) was investigated at Taro (200 m above sea level). There are set 150,0.4 sq m proportional counters on the bottom of the water tank.
Inoue, K. +3 more
core +1 more source
MATHEMATICAL MODELING FOR WATER HAMMER IN PIPE FLOW
Qassem H. Jalut, Nisreen Jawad Rasheed
openalex +1 more source
Discussion of “Water Hammer in PVC and Reinforced Plastic Pipe” [PDF]
David E. Goldberg, Michael A. Stoner
openalex +1 more source
Advancing the analysis of water pipe failures: a probabilistic framework for identifying significant factors. [PDF]
Muddassir M +3 more
europepmc +1 more source

