Results 281 to 290 of about 6,599,650 (377)

FACTOR ANALYSIS OF THE DETERIORATION OF WATER PIPELINES’ INNER SURFACES USING AN IN-PIPE ENDOSCOPE CAMERA

open access: diamond, 2019
Takaharu KUNIZANE   +6 more
openalex   +2 more sources

Fluorescence Properties and Mg2+ Selectivity of Aryl‐Alkynyl Derivatives of the o‐Aminophenoltriacetate (APTRA) Ligand

open access: yesChemistry – A European Journal, EarlyView.
It is a challenge to improve the selectivity of high‐denticity ligands for Mg2+ over Ca2+. We show that in aryl‐alkynyl derivatives of APTRA, electron‐withdrawing substituents lower the binding affinity for Ca2+ more than Mg2+, making the ligand more selective for Mg2+.
Laura L. Duncan   +2 more
wiley   +1 more source

Community health assessment: Knowledge, attitude and practice of women regarding water-pipe smoking in Bandar Abbas. [PDF]

open access: yesMethodsX, 2019
Faghir Ganji M   +8 more
europepmc   +1 more source

On the Usability of Pt/Al2O3 Catalysts for Exhaust Gas After Treatment in Ammonia Combustion Engines

open access: yesChemie Ingenieur Technik, EarlyView.
Ammonia engines emit no CO2 but exhibit elevated emissions of NH3 and NOx, where conventional SCR systems are not effective due to the significant excess of NH3. This study investigates Pt‐based oxidation catalysts in a bypass configuration to adjust the NH3/NOx ratio, analyzing catalyst parameters and their impact on N2O formation to identify optimal ...
J. Breuer   +2 more
wiley   +1 more source

A Methodology to Integrate Closed‐Cycle Heat Pumps into Batch Distillation Columns

open access: yesChemie Ingenieur Technik, EarlyView.
Batch distillation often cannot use vapor recompression due to contamination risks in food and pharma. This study proposes a design for integrating closed‐loop heat pumps using natural fluids. Results show significant energy savings, offering a sustainable alternative to traditional setups.
Philipp Dorn   +5 more
wiley   +1 more source

Modelling of continuous low‐temperature emulsion co‐polymerization in 3D‐printed reactor

open access: yesThe Canadian Journal of Chemical Engineering, EarlyView.
A kinetic model for the emulsion copolymerization of butyl acrylate/styrene at low temperatures is proposed and validated against experiments with a redox initiator system. The model was successfully transferred to a 3D‐printed tubular reactor and conversions of more than 80% and small particles sizes below 40 nm were observed.
Ferel Issa   +2 more
wiley   +1 more source

Home - About - Disclaimer - Privacy