Ultrasensitive Anti‐Stokes Luminescence Thermometry in Transition Metal Dichalcogenide Monolayers
We demonstrate a highly sensitive nanothermometer using anti‐Stokes photoluminescence, also known as photoluminescence upconversion (UPL), in monolayer tungsten disulfide. A strong resonantly enhanced UPL is observed, confirming the central role of optical phonons in the PL upconversion mechanism.
Sharada Nagarkar +6 more
wiley +1 more source
Association between volume per injection and treatment failure after water vapor thermal therapy. [PDF]
Okabe T.
europepmc +1 more source
This work demonstrates a scalable, low‐temperature synthesis strategy that combines a thioacetamide (TA)‐based dual sulfur source with CdS chlorination, enabling the formation of high‐quality Sb2S3 with a reduced open‐circuit voltage loss, resulting in improved device efficiency.
Vijay C. Karade +16 more
wiley +1 more source
Modified water vapor thermal therapy for large-volume benign prostatic hyperplasia. [PDF]
Lu Q +7 more
europepmc +1 more source
A quantum dot–tellurium thin‐film photodetector autonomously discriminates visible and infrared wavelengths through polarity‐reversible photoresponses. Engineered carrier separation and gain modulation enable filter‐free multispectral sensing within a single‐device architecture.
Yong Min Lee +7 more
wiley +1 more source
The study of the effect of water vapour in methane and helium on humidity sensing
This thesis was submitted for the degree of Master of Philosophy and awarded by Brunel University.The calibration of humidity sensors is usually carried out in air and at near ambient pressure.
Pothinual, Wepawadee
core
Photoacoustic Permeability Detection to Both Water Vapor and Artificial Tears of PVDF Transfer Membranes as a Piezoelectric and Ferroelectric Polymer. [PDF]
Aguilar-Mejía OE +4 more
europepmc +1 more source
3D Printing Innovations in Polymeric Porous and Patterned Architecture
Polymeric foams occupy a unique structural space between dense solids and open networks, where engineered void fraction governs mechanical compliance, thermal resistance, and mass transport. Additive manufacturing now enables precise spatial control over cellular architecture, unlocking designer foam structures across applications spanning crash ...
Dhanush Patil +13 more
wiley +1 more source
Airborne differential absorption lidar measurements of mid-latitude, subtropical and tropical water vapour were performed during several recent campaigns over North and South America, and Australia, as well as on the corresponding long-range transfer ...
Flentje, Harald +4 more
core
Thermocompressed Chickpea-Flour Sheets Reinforced with Cellulose Nanocrystals: Improved Water-Vapor Barrier and Thermo-Mechanical Performance. [PDF]
Flores-Huicochea E +7 more
europepmc +1 more source

