Results 131 to 140 of about 307,069 (348)
Enhanced Strength and Corrosion Resistance of Ti‐13Nb‐12Ta‐10Zr‐4Sn Alloy by Aging Treatment
This work systematically investigates the effect of aging treatment on mechanical properties and corrosion behavior of vacuum arc‐melted Ti‐13Nb‐12Ta‐10Zr‐4Sn alloy. Owing to the increased α″ martensite, strength and corrosion resistance were significantly enhanced by aging treatment.
Yuhua Li +5 more
wiley +1 more source
BackgroundElectroporation technology can be used in biomedicine, food safety, sewage treatment and other fields. The pulse waveform is an important parameter affecting electroporation efficiency.PurposeThis study aims to propose a distributed arbitrary ...
LIU Yuanhao +5 more
doaj +1 more source
The Influence of Heat Input Ratio on Electrical Power Output of a Dual-Core Travelling-Wave Thermoacoustic Engine [PDF]
This paper presents an analytical and experimental investigation of an electricity generator that employs a two-stage looped tube travellin -wave thermoacoustic prime-mover to deliver acoustic power from heat energy, a loudspeaker to extract electricity ...
Hann, D. +3 more
core
Viktoriia Shtefan, Thorgund Nemec, Ute Hempel, Annett Gebert and coworkers demonstrate that anodic treatment of Ti–Cu‐based metallic glass in a nontoxic pyrophosphate electrolyte forms a protective bilayered Ti/Zr‐oxide film enriched with Cu nanocrystals.
Viktoriia Shtefan +8 more
wiley +1 more source
Scandium (Sc)‐doped AlCoCrFeMo HEA coatings are fabricated via flame spraying with 0.1, 0.3, and 0.5 wt% Sc additions. Among these, the HEA‐Sc0.3 coating exhibits the highest corrosion resistance, indicated by a more positive corrosion potential and lower current density.
Pankaj Kumar +7 more
wiley +1 more source
A distinct semi‐confined inner‐tube chemical vapor deposition geometry enables reproducible, large‐area growth of phase‐pure 2D β′‐In2Se3 from InI + Se precursors. Engineering local vapor transport and optimizing precursor delivery and temperature–time conditions yield uniform continuous films.
Dasun P. W. Guruge +8 more
wiley +1 more source
This paper analysis radiation conditions of an acoustic wave in an axial generator with outlets of the stator entering a common horn with a ring-shaped cross section. Acoustic properties of the generator horn, including the wave reflected from the outlet,
Tomasz ZAMORSKI
doaj
Accuracy analysis of the wave gear with a disk wave generator [PDF]
МГТУ им. Н.Э. Баумана +7 more
openalex +1 more source
Photoswitchable Conductive Metal–Organic Frameworks
A conductive material where the conductivity can be modulated remotely by irradiation with light is presented. It is based on films of conductive metal–organic framework type Cu3(HHTP)2 with embedded photochromic molecules such as azobenzene, diarylethene, spiropyran, and hexaarylbiimidazole in the pores.
Yidong Liu +5 more
wiley +1 more source

