Results 11 to 20 of about 591,365 (249)
Sliding wear of nitrided steels [PDF]
, 1993 This thesis was submitted for the degree of Doctor of Philosophy and awarded by Brunel University.The unlubricated sliding wear behaviour of gas nitrided, plasma nitrided, and ferritic nitrocarburized BS970,905M39 (EN41B) steels was investigated ...
Kato, Hirotaka
core +6 more sources
Wear maps for TiC composite based coatings deposited on 303 stainless steel [PDF]
, 2014 Dry sliding wear (pin-on-disc) tests were carried out under ambient conditions at room temperature for TiC coated and uncoated 303 stainless steel, using alumina as a counterface.
Stack, M.M., Rasool, G.
core +4 more sources
Influence of temperature and crystal orientation on tool wear during single point diamond turning of silicon [PDF]
, 2012 Owing to the capricious wear of cutting tools, ultra precision manufacturing of silicon through single point diamond turning (SPDT) operation becomes a challenging task.
Reuben, Robert L +3 more
core +2 more sources
Wear mechanisms of TiN coated tools during high-speed tapping of GGG50 nodular cast iron
, 2023 Ductile irons are among the most used materials in the automotive industry. One of the critical problems during manufacturing of powertrain components is the fast wear of cutting tools because it can lead to defects in the part.
Veiga, Fernando +3 more
core +1 more source
Running-in wear modeling of honed surface for combustion engine cylinder liners [PDF]
, 2013 The texture change during running-in alters the performance and efficiency of a tribo-mechanical system. During mass production of cylinder liners, a final finishing stage known as ‘‘plateau honing’’ is commonly added to reduce the running-in wear ...
EL MANSORI, Mohamed +3 more
core +1 more source
Nanomaterials, 2020 Natural serpentine powders are applicable as additives for various lubricating oils. However, no uniform theories explain their tribological performance, lubrication, and wear mechanism, especially their self-repairing mechanism. Herein, the influence of
Binbin Wang +6 more
doaj +1 more source
Nanomaterials, 2022 Two carbonaceous (amorphous carbon and graphene) coatings were catalytically grown on bulk Ni plates. It was found that the flame-deposited carbon (FDC) layers exhibited a unique hierarchical structure with the formation of FDC/Ni nano-interlocking ...
Wei Meng +4 more
doaj +1 more source
Wear Measuring and Wear Modelling Based on Archard, ASTM, and Neural Network Models [PDF]
, 2015 The wear measuring and wear modelling are a fundamental issue in the industrial field, mainly correlated to the economy and safety. Therefore, there is a need to study the wear measurements and wear estimation.
Pislaru, Crinela, Shebani, Amer
core +2 more sources
Predicting wear of UHMWPE: decreasing wear rate following a change in direction [PDF]
, 2011 Computational tools are emerging as design tools for the development of total joint replacement with improved wear performance. The current wear models of polyethylene assume that wear is linearly proportional to sliding distance; however, it is ...
Render, Todd D. +9 more
core +1 more source
Wear Reducing Effect of Embedded Quartz Abrasives in Crushing-Pin-on-Disc Procedure
Tribology Online, 2012 Crushing of minerals involves several wear mechanisms. The mineral medium increases the complexity of the wear process by introducing many new variables.
Vuokko Heino +4 more
doaj +1 more source