Results 41 to 50 of about 903,846 (372)
Crystals, 2022 As for metal matrix composites (MMCs), the selection and application of reinforcements play a vital role in their comprehensive properties. In this work, the CrCoNi medium entropy alloy (MEA) was selected as reinforcement for Al matrix composites, and ...
Yue Wu +8 more
doaj +1 more source
Validation of accelerometer wear and nonwear time classification algorithm.
Medicine & Science in Sports & Exercise, 2011 INTRODUCTION the use of movement monitors (accelerometers) for measuring physical activity (PA) in intervention and population-based studies is becoming a standard methodology for the objective measurement of sedentary and active behaviors and for the ...
Leena Choi +3 more
semanticscholar +1 more source
Wear transitions in a wear coefficient model [PDF]
Wear, 2009 The value chosen for the empirical wear coefficient in the frictional-work wear model greatly affects wear simulation results such as those for predicting rail corrugation growth. Furthermore, experimental results have widely shown that this wear coefficient is strongly dependent on the type of wear process involved, however these wear regimes are only
Vuong, T. T., Meehan, P. A.
openaire +3 more sources
Case Report: Renal potassium wasting in SARS-CoV-2 infection [version 2; peer review: 2 approved]
F1000Research, 2020 Severe acute respiratory syndrome coronavirus 2 (SARS-CoV-2) infection is associated with many potentially fatal complications. Renal involvement in various forms is common in addition to serum electrolyte disturbances.
Holly Mabillard +5 more
doaj +1 more source
Science Advances, 2019 Triboemission of hydrocarbon molecules such as methane and ethylene induces chemical and mechanical wear of diamond-like carbon. Understanding atomic-scale wear is crucial to avoid device failure.
Yang Wang +12 more
semanticscholar +1 more source
Strain effects on the wear rate of severely deformed copper [PDF]
arXiv, 2021 A variety of severe plastic deformation (SPD) techniques have been developed to process materials to high strains and impart microstructural refinement. High pressure torsion (HPT) is one technique that imparts inhomogeneous strain to process discs with low strain in the center and high strain at the outer edge. In the literature, this inhomogeneity is
arxiv
Wear-resistant thin films of MRI-230D-Mg alloy using plasma-driven electrolytic oxidation [PDF]
Wear 271, 1987 (2011), 2017 Wear resistant coatings were produced on a permanent mould cast MRI 230D Mg alloy by (a) PEO in silicate based electrolyte, (b) PEO in phosphate based electrolyte, (c) hybrid coatings of silicate PEO followed by laser surface alloying (LSA) with Al and Al2O3, and (d) hybrid coatings of phosphate PEO followed by LSA with Al and Al2O3.
arxiv +1 more source
BJPsych OpenAims This clinical audit aimed to assess if the recording of patients seen for their diagnostic appointments in memory clinic measures up to the minimum standards required in the delivery of dementia services.
Karyn Ohioma +4 more
doaj +1 more source
Resilient Cities and Structures, 2023 Extreme weather conditions can adversely impact transport networks and driver behaviour, leading to variations in traffic volumes and travel times and increased accident rates.
Kristina Wolf +5 more
doaj
Critical length scale controls adhesive wear mechanisms
Nature Communications, 2016 The adhesive wear process remains one of the least understood areas of mechanics. While it has long been established that adhesive wear is a direct result of contacting surface asperities, an agreed upon understanding of how contacting asperities lead to
R. Aghababaei, D. Warner, J. Molinari
semanticscholar +1 more source